Abstract:This research delves into the numerical predictions of fill-level and residence time distribution (RTD) in starve-fed single-screw extrusion systems. Starve-feeding, predominantly used in ceramic extrusion, introduces challenges which this study seeks to address. Based on a physical industrial system, a comprehensive 3D computational fluid dynamics (CFD) model was developed using a porous media representation of the complex multi-hole plate die. Validations performed using real sensor data, accounting for partial wear on auger screw flights, show an ~11% discrepancy without accounting for screw wear and ~6% when considering it. A 2D convection-diffusion model was introduced as a dimensionality reduced order model (ROM) with the intention of bridging the gap between comprehensive CFD simulations and real-time applications. Central to this model's prediction ability was both the velocity field transfer from the CFD model and calibration of the ROM diffusion coefficient such that a precise agreement of residence time distribution (RTD) curves could be obtained. Some discrepancies between the CFD and the ROM were observed, attributed to the loss of physical information of the system when transitioning from a higher fidelity CFD model to a semi-mechanistic ROM and the inherent complexities of the starved flow in the compression zone of the extruder. This research offers a comprehensive methodology and insights into reduced order modeling of starve-fed extrusion systems, presenting opportunities for real-time optimization and enhanced process understanding.

Evaluation of Density Fields of Numerical Analysis Output of Solid Carbon Dioxide Extrusion Process

The Influence of Density on the Value of Young’s Modulus for Dry Ice

Influence of PPD and Mass Scaling Parameter on the Goodness of Fit of Dry Ice Compaction Curve Obtained in Numerical Simulations Utilizing Smoothed Particle Method (SPH) for Improving the Energy Efficiency of Dry Ice Compaction Process

Influence of Die Land Length on the Maximum Extrusion Force and Dry Ice Pellets Density in Ram Extrusion Process

Numerical Simulation of Dry Ice Compaction Process: Comparison of Drucker-Prager/Cap and Cam Clay Models with Experimental Results

Experimental Investigation on the Effect of Dry Ice Compression on the Poisson Ratio

Numerical Simulation of Dry Ice Compaction Process: Comparison of the Mohr–Coulomb Model with the Experimental Results

Method for Determining the Coefficient of Friction Variation Pattern as a Function of Density at Low Temperatures Using the Example of Dry Ice–Steel Contact

Analysis of Density Distribution in a Cylindrical Specimen under Compaction Using the Example of Dry Ice

Energy analysis of the extrusion process through a streamlined Gaussian die

Energy modeling and efficiency analysis of aluminum die-casting processes

Comparative analysis of flow factors and crystallinity in conventional extrusion and gas-assisted extrusion

Numerical and Experimental Studies on the Improvement of Gas Chamber Structure During Gas-Assisted Extrusion

Introduction to Modelling the Correlation Between Grain Sizes of Feed Material and the Structure and Efficiency of the Process of Co-Rotating Twin-Screw Extrusion of Non-Flammable Composites with a Pla Matrix

Numerical modeling of fill-level and residence time in starve-fed single-screw extrusion: a dimensionality reduction study from a 3D CFD model to a 2D convection-diffusion model

Progress in Numerical Simulation of Reactive Extrusion

A modified volumetric energy density–based approach for porosity assessment in additive manufacturing process design

Numerical Simulation and Analysis of the Effect of Some Materials and Processing Parameters on the Gas Assisted Extrusion of Ultra-high Molecular Weight Polyethylene

The influence of the limit stress value on the sublimation rate during the dry ice densification process