Abstract:Despite vast research on the utilisation of coal ashes in cement mortars, many studies lack a comprehensive evaluation of properties related to mortar for masonry and plaster work. This study investigate properties like workability, compressive strength, drying shrinkage, tensile bond strength and adhesive strength through a systematic replacement of river sand by pond ash in cement mortars. Volumetric mix proportions of 1:3, 1:4, 1:5 and 1:6 (cement: sand) were considered, where river sand was replaced in the range of 20–100% by pond ash. At 30% pond ash content, properties like the compressive strength, tensile bond strength and adhesive strength improved in the range of 21–30%, 13–20% and 14–24%, respectively, for all mix proportions. At 60% pond ash content, these strength properties were comparable with those of control mixes and found suitable for mortars for masonry works. However, the drying shrinkage increased with an increase in pond ash content. At 30% pond ash content, drying shrinkage increased in the range of 26–40% for all mix proportions. The thermogravimetric analysis (TGA) showed that mixes with pond ash demonstrated reduced portlandite content compared to the control mixes, resulting in the formation of secondary C-S-H gel. Simple regression models were developed based on experimental results to establish the relationships between different properties. Based on coefficient of determination ( R 2 ), variance inflation factor (VIF) and Durbin–Watson statistics, relationships between the strength and shrinkage properties were very well quantified to be used by researchers and practitioners. Utilisation of pond ash as partial replacement of river sand in mortars proved to be a useful step towards achieving circular economy at the same time reducing threat to depletion of limited natural resources.

Mortar with fly ash as a partial cement replacement: Analysing the compressive strength and heat of hydration

Microstructural and Compressive Strength Analysis for Cement Mortar with Industrial Waste Materials

Effect of Replacing Fine Aggregate with Fly Ash on the Performance of Mortar

Comparative Analysis of Woody Biomass Fly Ash and Class F Fly Ash as Supplementary Cementitious Materials in Mortar

Palm Oil Fuel Ash and Fly Ash for a Partial Replacement of Cement in High-Quality, Environmentally Friendly Mortar as a Solution to Industrial Waste

PROPERTIES OF CEMENT-FLY ASH MIXTURES WITH SUBSTANDARD FLY ASH AS A PARTIAL CEMENT AND FINE AGGREGATE REPLACEMENT

Assessment of the Combined Effect of Silica Fume, Fly Ash, and Steel Slag on the Mechanical Behavior of Concrete

Comparative study on net-zero masonry walls made of clay and fly ash bricks and grouts/mortars/stuccos with the effect of super fine fly ash blended cement—low carbon cement

The Early Age Strength Improvement of the High Volume Fly Ash Mortar

HIGH STRENGTH CONCRETE USING FLY ASH A CEMENT AND FINE AGGREGATE

Compressive strength, flexural strength, and durability of high-volume fly ash concrete

Development of novel mortar using fine river sand and pretreated waste flue gas desulfurization gypsum powder and pond fly ash

Experimental study on the mechanical behavior of concrete incorporating fly ash and marble powder waste

Prediction of compressive strength development for blended cement mortar considering fly ash fineness and replacement ratio

Compressive strength and workability of concrete using pozzolanic material as partial replacement of Ordinary Portland Cement (OPC)

Influence of class-F coal fly ash on workability, strength, and predictability of water requirement in paste and mortar formulations with reduced cement – a case in the Philippines

Use of Municipal Solid Waste Incineration Fly Ash As a Supplementary Cementitious Material: CO2 Mineralization Coupled with Mechanochemical Pretreatment.

Replacement of cement in concrete by fly ash and waste brick powder

A study on the synthesis and performance evaluation of fly ash and alccofine as sustainable cementitious materials

Evaluation of mechanical properties of cement mortars containing pond ash as partial replacement of river sand and prediction of properties by regression models

Effect of nano and micro iron oxide particles on the workability, strength and absorption rate of cement mortar containing fly ash