Abstract:Rock formations experience strength and stiffness degradation or enhancement, which is often reflected by an increase or decrease in the elastic constant. Such elastic constant variation in rock mass often causes the redistributions of the stress and strain; therefore, the geostructure stability is affected. However, to the best of the authors’ knowledge, no studies have been conducted to investigate this problem analytically. Therefore, based on Hooke’s law, this paper analyzed the stress, strain, and energy density distributions in a rock formation with such a variation in the elastic constant. Then, a general analytical solution was presented for two scenarios. One scenario was the elastic constant variation over the whole domain of rock mass, and the other was the elastic constant variation over the partial domain of interest. According to the law of thermodynamics, the elastic constant and stress components could be expressed as a function of the elastic strain energy density (ψ). Then, the stress and strain components distributions after the elastic constant variation could be directly correlated to those that developed before the elastic constant variation. The analysis showed that the stress components before and after the elastic constant variations were unchanged for the case with a variation in the elastic constant over the whole domain of interest. In contrast, in this case, the strain components after the elastic constant change were equal to 1/R times the strain components before the elastic constant change. In this paper, the ratio of elastic constants after the change to before the change was R. The analysis showed that the strain components before and after the elastic constant changes were the same for cases where the elastic constant varied over the partial domain of interest. However, in this case, the stress components after the elastic constant change were equal to R times the stress components that developed before the elastic constant change in this partial domain. The analytical model was verified through numerical simulation with the help of ABAQUS.

On transformation strains and uniform fields in multiphase elastic media

Analysis of Strain Localization in Porous Media with Transversely Isotropic Elasticity under Undrained Conditions

Investigation of Strain Localization in Elastoplastic Materials with Transversely Isotropic Elasticity

The non-uniform transformation strain problem for an anisotropic ellipsoidal inclusion

The effect of mechanical strains on the ferroelectric and dielectric properties of a model single crystal ? Phase field simulation

Green'S Function and Eshelby'S Fields in Couple-Stress Elasticity

Expansion of Spherical Cavity of Strain-Softening Materials with Different Elastic Moduli of Tension and Compression

“Driving forces” and radiated fields for expanding/shrinking half-space and strip inclusions with general eigenstrain

Do multiphysics processes lead to mesh independent analyses?

Multiscale enhanced non‐uniform transformation field analysis

Strain localization regularization and patterns formation in rate-dependent plastic materials with multiphysics coupling

The innate interfacial elastic strain field of a transformable B2 precipitate embedded in an amorphous matrix

Transformation Properties of the Lagrangian and Eulerian Strain Tensors

Energy variation and stress fields of spherical inclusions with eigenstrain in three-dimensional anisotropic bi-materials

Analysis of shear localization in viscoplastic solids with pressure-sensitive structural transformations

Continuum modeling of strain-induced martensitic transformation at shear-band intersections

A combined phase field approach for martensitic transformations and damage

Theoretical Solution for Stress and Strain Distributions Induced by Generalized Elastic Constant Variation in Rock Mass

Modeling martensitic transformation in shape memory alloys using multi-phase-field elasticity models based on partial rank-one energy relaxation on pairwise interfaces

Modelling of martensitic phase transformation accounting for inertia effects

A three-dimensional phase-field model for studying the orientation-dependent interface evolution in stress-induced martensitic phase transformation