Abstract:During previous medium intensity earthquakes, several cantilevered retaining structures shoring waterfront areas experienced large deformations or even collapsed. This was in contrary to the caisson type quay walls which performed better even during the very strong 1995 Kobe earthquake. Within this realm, recent studies have highlighted that saturated backfill adjacent to retaining structures may not fully liquefy and has a strong potential for shear-induced dilation mechanics owing to the presence of substantial static shear. However, despite these negative excess pore pressures and absence of a full liquefaction state in the backfill, cantilevered retaining walls may still experience large deformations. In this paper, a deformation mechanism is proposed for an embedded cantilever retaining wall supporting a submerged backfill made of Ottawa F-65 sand using a geotechnical centrifuge experiment. The dynamic response of the soil–structure system was measured, and the intra-cyclic mechanics were investigated. The entire earthquake duration of 20 s was divided into three different phases. In phase I (comprising of initial 6 s), the retaining wall experienced "sliding" deformations owing to its inertia with negligible soil straining at the backfill. Under the application of subsequent seismic pulses in phase II, large suction drops in excess pore pressures were observed during the translation of the retaining wall toward the backfill, which caused the negative excess pore pressure to exceed the hydrostatic value. However, the temporary release of the suction drops during the deformation of the wall toward the seaside resulted in significant softening as soil crosses the phase-transformation line. This ultimately resulted in significant plasticization of the backfill, and the wall initiated a "rotation" type deformation mechanism with a pivot point located near its base. Intra-cyclic observations revealed an increase in the magnitude of the phase transition in excess pore pressures, which contributed to the increased accumulated soil straining along the backfill. Owing to this, the wall experienced increasing rotations with the application of subsequent cycles in phase II (until 14 s) until the passive resistance in front of the wall was fully mobilized. However, a sudden catastrophic collapse of the wall could be avoided owing to the re-dilation mechanism, during which the soil again underwent a phase transformation and generated negative excess pore pressures on the completion of the wall translation toward the seaside. With the reduction in the amplitude of the applied cycles toward the end of shaking (phase III), the effective stress path in front of the wall moved away from the origin, and the mobilized passive stress reduced, which eventually resulted in the retaining wall achieving a stable state with no additional deformations. The proposed deformation mechanism highlights that a state of full liquefaction is not a necessary prerequisite for an embedded cantilever retaining wall to experience significant deformations, and an understanding of suction mechanics during excess pore pressure generation is critical.

Damage analysis of the cut-off wall in a landslide dam based on centrifuge and numerical modeling

Extended DDA with Rotation Remedies and Cohesive Crack Model for Simulation of the Dynamic Seismic Landslide

Three-dimensional refined analysis of seismic cracking and anti-seismic measures performance of concrete face slab in CFRDs

A parabolic model and an iterative algorithm for the slab-cushion interface and the application in simulating the dynamic separation between the face slabs and cushion layer

Analysis of Damage and Cracking in Arch Dams Subjected to Extremely Strong Earthquake

Numerical Analysis on Stress and Deformation of the Earth-rock Dam Cutoff Wall Using Low Elastic Modulus Concrete

Safety analysis of nonlinear dynamic damage in Longtan concrete gravity dam under earthquake load

Two-dimensional DEM-FEM coupling analysis of seismic failure and anti-seismic measures for concrete faced rockfill dam

FEM Analysis of Stress-Deformation Characteristics of Cut-off Walls in High Core Rockfill Dam

Dynamic analyses of a high earth-rockfill dam considering effects of solid-fluid coupling

The simulation of high compressive stress and extrusion phenomenon for concrete face slabs in CFRDs under strong seismic loads

Numerical Simulation on the Longitudinal Breach Process of Landslide Dams Using an Improved Coupled DEM-CFD Method

Numerical modeling of soil–structure interface of a concrete-faced rockfill dam

Numerical simulation of cracks of homogeneous earth dams using an extended finite element method

Study on Working Behaviors and Improvement Strategies of Concrete Cutoff Wall with Slurry Cake in Thick Soil Foundation

Failure Analysis of Gravity Dams with Existing Cracks Based on Extended Finite Element Method

Experimental Study on Cracking and Integrity Stability of Xiluodu Arch Dam

Experimental and numerical study on the breaching mechanisms of landslide dams with non-uniform structures

A Primary Analysis of Seismic Behavior and Damage for Zipingpu CFRD during Wenchuan Earthquake

Dynamic centrifuge modeling to investigate the deformation mechanism of an embedded cantilever retaining wall with submerged backfill conditions

Numerical simulation analysis of damage mode of concrete gravity dam under close-in explosion