A Comparative Study of Molecular Imprinting Techniques Used for Fabrication of Electrochemical Sensor of Olaparib

S. Irem Kaya,Mahsa Majidian,Goksu Ozcelikay-Akyildiz,Ahmet Cetinkaya,Burcu Dogan Topal,Esen Bellur Atici,Sibel A. Ozkan,S. Irem KAYA,Goksu Ozcelikay,Sibel A. A OZKAN
DOI: https://doi.org/10.1149/1945-7111/acf620
IF: 3.9
2023-09-03
Journal of The Electrochemical Society
Abstract:This study reports a molecular imprinting process investigated by two techniques: photopolymerization (PP) and thermal polymerization (TP). These techniques were integrated with an electrochemical sensor to detect the new generation anticancer drug Olaparib (OLP), which is a PARP inhibitor with high sensitivity and selectivity. The PP-MIP film was formed by PP, while TP-MIP film was formed by TP on a GCE. In the PP-MIP(OLP)/GCE sensor, which was developed using PP, 4-aminobenzoic acid (4-AB) as a functional monomer was designed, and obtained in the presence of basic monomer (HEMA, 2-hydroxyethyl methacrylate), crosslinker (EGDMA, ethylene glycol dimethacrylate), and initiator by keeping it under a UV lamp at 365 nm. For TP-MIP(OLP)/GCE was obtained by using a mixture of 4-AB as a functional monomer, NH3 solution, surfactant (SDS), and tetraethyl orthosilicate : ethanol (1:1, v/v) and keeping it in an oven at 50°C for 40 min. After each process, the GCE surfaces were characterized via scanning electron microscope and electrochemical techniques.The required optimization studies were performed for both techniques. After obtaining the optimum MIP-integrated electrochemical sensors, the analytical performances of PP-MIP(OLP)/GCE and TP-MIP(OLP)/GCE were evaluated, and the validation parameters were compared. The linear ranges of PP-MIP(OLP)/GCE and TP-MIP(OLP)/GCE are 0.1-1 nM.
electrochemistry,materials science, coatings & films
What problem does this paper attempt to address?