Non-graphitized carbon/Cu2O/Cu0 nanohybrids with improved stability and enhanced photocatalytic H2 production

Areti Zindrou,Loukas Belles,Maria Solakidou,Nikos Boukos,Yiannis Deligiannakis
DOI: https://doi.org/10.1038/s41598-023-41211-4
IF: 17.694
2023-08-27
NanoScience and Technology
Abstract:Cu 2 O is a highly potent photocatalyst, however photocorrosion stands as a key obstacle for its stability in photocatalytic technologies. Herein, we show that nanohybrids of Cu 2 O/Cu 0 nanoparticles interfaced with non-graphitized carbon (nGC) constitute a novel synthesis route towards stable Cu-photocatalysts with minimized photocorrosion. Using a Flame Spray Pyrolysis (FSP) process that allows synthesis of anoxic-Cu phases, we have developed in one-step a library of Cu 2 O/Cu 0 nanocatalysts interfaced with nGC, optimized for enhanced photocatalytic H 2 production from H 2 O. Co-optimization of the nGC and the Cu 2 O/Cu 0 ratio is shown to be a key strategy for high H 2 production, > 4700 μmoles g −1 h −1 plus enhanced stability against photocorrosion, and onset potential of 0.234 V vs. RHE. After 4 repetitive reuses the catalyst is shown to lose less than 5% of its photocatalytic efficiency, while photocorrosion was < 6%. In contrast, interfacing of Cu 2 O/Cu 0 with graphitized-C is not as efficient. Raman, FT-IR and TGA data are analyzed to explain the undelaying structural functional mechanisms where the tight interfacing of nGC with the Cu 2 O/Cu 0 nanophases is the preferred configuration. The present findings can be useful for wider technological goals that demand low-cost engineering, high stability Cu-nanodevices, prepared with industrially scalable process.
What problem does this paper attempt to address?