Abstract:Thermogravimetric data obtained is interpreted using novel non‐isothermal integral method and compared it with several kinetic models. By comparison the activation energies, it has been concluded that new integral method gave the sharp range and consistent value with highest correlation coefficient, indicating that new developed non‐isothermal method is most suitable for determination of kinetic parameters. The kinetic parameters seem to be very helpful in investigating the reaction mechanism of the solid‐state reactions in real system and will give an opportunity to develop the mechanism of the decomposition reaction. A tremendous increase in municipal plastic waste is observed due to high consumption of polymers. With the passage of time the available landfills for discarding of waste plastics decrease whereas, appropriate recycling methods for waste plastics gaining more and more importance. In the present work thermal decomposition of polystyrene (PS) and polyethylene (PE) waste mixture was carried out at different heating rates (5, 10, 15 and 20 °C/min) in a thermogravimetric analyzer (TGA). Thermogravimetric data obtained was further interpreted using new developed non‐isothermal integral method and compared it with several kinetic models i. e., Coats Redfern (CR), Ozawa Flynn Wall (OFW), Kissinger‐Akahira‐Sunose (KAS), Achar and Criado‐Dollimore (CD). The activation energy (Ea) calculated using CR, OFW, KAS, Achar and CD models were found to be in the range of 92.7–130.6, 85.3–120.1, 82.1–113.2, 114.8–162.1 and 95.4–134.4 kJmol−1 respectively, whereas Ea determined by using new developed non‐isothermal method was found to be in the range 70.9 to 106.3 kJmol−1.By comparison the activation energies, it has been concluded that new integral method gave the sharp range and consistent value with highest correlation coefficient, indicating that new developed non‐isothermal method is most suitable for determination of kinetic parameters. The kinetic parameters seem to be very helpful in investigating the reaction mechanism of the solid‐state reactions in real system and will give an opportunity to develop the mechanism of the decomposition reaction.

Modified Friedman isoconversional kinetic method for effective activation energies of waste tires rubber pyrolysis

Co-pyrolysis of Corn Stover and Waste Tire: Pyrolysis Behavior and Kinetic Study Based on Fraser-Suzuki Deconvolution Procedure

Mechanistic insights into co-pyrolysis of waste tires and waste lubricating oil: Kinetics and thermal behavior study

Mathematical Model for Mass and Heat Transfer in Multilevel Reactor for Pyrolysis of Used Tyres

Study on pyrolysis characteristics, kinetics and thermodynamics of waste tires catalytic pyrolysis with low-cost catalysts

Kinetic analysis of waste tire pyrolysis with metal oxide and zeolitic catalysts

Pyrolysis reaction models of waste tires: Application of Master-Plots method for energy conversion via devolatilization

A Modified Temperature Integral Approximation Formula and Its Application in Pyrolysis Kinetic Parameters of Waste Tire

Insight into Pyrolysis Kinetics of Lignocellulosic Biomass: Isoconversional Kinetic Analysis by the Modified Friedman Method

Investigating Kinetic Behavior and Reaction Mechanism on Autothermal Pyrolysis of Polyethylene Plastic

Dynamic Pyrolysis Characteristics, Kinetics and Products Analysis of Waste Tire Catalytic Pyrolysis with Ni/Fe-ZSM-5 Catalysts Using TG-IR-GC/MS

Pyrolysis study of a waste plastic mixture through different kinetic models using isothermal and nonisothermal mechanism

Kinetic studies on the pyrolysis of plastic waste using a combination of model-fitting and model-free methods

Kinetic triplet determination and modified mechanism function construction for thermo-oxidative degradation of waste polyurethane foam using conventional methods and distributed activation energy model method

Pyrolysis kinetics and characteristics of waste tyres: Products distribution and optimization via TG-FTIR-MS and rapid infrared heating techniques

Kinetic study of pyrolysis of waste polystyrene and polyethylene mixture using novel non‐isothermal method

Kinetic Analysis of Thermal Degradation of Recycled Polypropylene and Polystyrene Mixtures Using Regenerated Catalyst from Fluidized Catalytic Cracking Process (FCC)

Kinetic investigation on the catalytic pyrolysis of plastic fractions of waste electrical and electronic equipment (WEEE): A mathematical deconvolution approach

Pyrolysis and Oxidative Thermal Decomposition Investigations of Tennis Ball Rubber Wastes through Kinetic and Thermodynamic Evaluations

Isoconversional Kinetic Analysis of Distributed Activation Energy Model Processes for Pyrolysis of Solid Fuels

Characteristics, kinetics, infrared analysis and process optimization of co-pyrolysis of waste tires and oily sludge