Abstract:Synaptic elements capable of reversible multilevel analog switching have the potential to become key components in future neuromorphic computing technologies and exceed the practical limits of current digital technology. Artificial neural networks based on analog synapses could potentially deliver performance one step closer to the human brain which far surpasses the efficiency of current computing capabilities by many orders of magnitude. For example, this could be achieved by mapping the synaptic weights of deep neural net on the multi-bit device and performing the multiply-accumulate operation in-memory during learning or inferencing cycles [1]. While different types of 2-terminal emerging non-volatile memory, such as phase change memory (PCM) or resistive RAM (ReRAM), permit some degree of reversible analog tuneability, they exhibit significant stochasticity, and asymmetry which are detrimental to learning accuracy. In addition to precise and predictable control of the resistance state, decoupling the write and read cycle is a major challenge for the practical application of such devices. Memistor-based three-terminal devices allow decoupling the read and write steps, potentially permitting drastic increase in device operational precision and reliability. Electrochemical copper plating devices of this type for the purpose of “adaptive switching circuits” were conceived as early as the1960s in the ADALINE neuron element [2] and more recently as “atomic transistors” [3], however these devices utilized liquid electrolytes which are a big challenge for practical fabrication of an integrated chip. Other systems, such as lithium-based intercalation materials have been used for solid-state three-terminal synaptic devices and scaled to sub-micron dimensions [4], [5]. However. Li+ based systems are chemically reactive and sensitive to atmospheric exposure while also possessing a residual open circuit potential which opposes continued potentiation and creates challenges for voltage-driven neural networks. Here, we report a solid-state, lithium-free, Cu+-based 3-terminal synaptic device capable of reversible multilevel switching. Cu+ is driven in or out of a channel to create a conductance change and Cu+ ion transport is achieved through a solid electrolyte by writing pulses of only 100mV with near-zero open circuit potential. We analyze device performance, physical, and chemical characteristics, and provide insight into operation mechanisms and limitations. Exceptionally high ionic conductivity of 0.36S/cm (significantly higher than any reported solid-state lithium-based system) was measured in the electrolyte by impedance spectroscopy which is critical for high speed device operation. The first device prototypes were over 100 microns in size with very low dynamic range and channel resistance of only several hundred ohms, which is too low for practical applications. We demonstrate a path for increasing the dynamic range and channel resistance of our devices, as well as first steps towards transfer to sub-micron scale fabrication. Figure 1 Impedance spectrum of solid copper electrolyte with inset micrograph of completed device in measurement setup (a). Schematics of device structure and operation (b). Channel resistivity change during cycling measured between writing pulses (two consecutive cycles of 5, +100mV, and 5,-100mV pulses each). Reference: [1] T. Gokmen, Y Vlasov, Frontiers in Neuroscience 2016, 10, 333 [2] B. Wirdow. Technical Report No1553-2, Office of Naval Research 1960 [3] Xie et al. Beilstein J. Nanotechnol. 2017, 8, 530–538 [4] Fuller et al. Li-Ion Synaptic Transistor for Low Power Analog Computing. Adv. Mater. 2017, 29 [5] J.Tang et al, presented at IEEE IEDM 2018, 13.1 Figure 1

Redox MXene Artificial Synapse with Bidirectional Plasticity and Hypersensitive Responsibility

Tunable Resistive Switching Enabled by Malleable Redox Reaction in the Nano-Vacuum Gap

Mixed-Dimensional Nanoparticle–Nanowire Channels for Flexible Optoelectronic Artificial Synapse with Enhanced Photoelectric Response and Asymmetric Bidirectional Plasticity

Electrochemical and Thermodynamic Processes of Metal Nanoclusters Enabled Biorealistic Synapses and Leaky-Integrate-and-fire Neurons

Flexible Artificial Memristive Synapse Constructed from Solution‐Processed MgO–Graphene Oxide Quantum Dot Hybrid Films

Brain-Like Optoelectronic Artificial Synapse with Ultralow Energy Consumption Based on MXene Floating-Gate for Emotion Recognition

A hybrid ambipolar synaptic transistor emulating multiplexed neurotransmission for motivation control and experience-dependent learning

Bipolar to Unipolar Mode Transition and Imitation of Metaplasticity in Oxide Based Memristors with Enhanced Ionic Conductivity

Electrochemical‐Memristor‐Based Artificial Neurons and Synapses—Fundamentals, Applications, and Challenges

Copper-Based 3-Terminal Synaptic Cell with Multiple Resistance Levels

Artificial Synapse Based on van der Waals Heterostructures with Tunable Synaptic Functions for Neuromorphic Computing

Synaptic learning behavior and neuromorphic computing of Au/MXene/NiO/FTO artificial synapse

Behavioral compliance with medical therapies.

Ultrasensitive Freestanding and Mechanically Durable Artificial Synapse with Attojoule Power Based on Na‐Salt Doped Polymer for Biocompatible Neuromorphic Interface

Flexible electronic synapse enabled by ferroelectric field effect transistor for robust neuromorphic computing

Oxide-Based Synaptic Transistors for Neuromorphic Systems

Multi-Stimuli-Responsive Synapse Based on Vertical Van Der Waals Heterostructures.

Flexible Low‐Voltage MXene Floating‐Gate Synaptic Transistor for Neuromorphic Computing and Cognitive Learning

A Flexible Organic Electrochemical Synaptic Transistor With Dopamine-Mediated Plasticity

Tactile tribotronic reconfigurable p-n junctions for artificial synapses

Opto‐electrochemical Synaptic Memory in Supramolecularly Engineered Janus 2d MoS 2