Mitigation of carrier trapping effects on carrier lifetime measurements with continuous-wave laser illumination for Pb-based metal halide perovskite materials

Ntumba Lobo,Gebhard J. Matt,Andres Osvet,Shreetu Shrestha,Andrii Kanak,Petro Fochuk,Christoph J. Brabec,Masashi Kato

DOI: https://doi.org/10.1063/5.0181654

IF: 2.877

2024-02-21

Journal of Applied Physics

Abstract:We investigated the impact of carrier trapping on the carrier lifetime of metal halide perovskite materials, which are key to solar cell production. We examined NH3CH3PbI3 (MAPbI3), NH3CH3PbBr3 (MAPbBr3), and CsPbBr3 using continuous-wave (CW) laser illumination during microwave photoconductivity decay (μ-PCD) measurements. Traditional pulsed light excitation falls short of mirroring solar cell operating conditions, owing to carrier trapping. Implementing CW laser illumination provides a more accurate estimation of the carrier lifetimes under operational conditions. With an increased photon flux from the CW laser, the μ-PCD decay curves changed, indicating reduced recombination via traps. The experiments revealed extended carrier lifetimes under continuous light for the MAPbI3 polycrystal. This suggests that CW lasers can mitigate trapping effects on carrier lifetime measurements. For the other samples, carrier trapping had a negligible effect on the measured carrier lifetimes. We believe that these findings will aid in the design of perovskite-based devices.

physics, applied

What problem does this paper attempt to address?

The paper aims to address the impact of carrier trap effects on carrier lifetime measurements in metal halide perovskite materials. Specifically, the study focuses on the following points:

1. **Limitations of traditional measurement methods**: Traditional pulsed light excitation methods cannot accurately reflect the performance of solar cells under actual working conditions when measuring carrier lifetime, as pulsed light excitation easily leads to carrier trapping, thereby affecting the measurement results.

2. **Application of continuous wave laser illumination**: By using continuous wave (CW) laser illumination, the study investigates the carrier trap effects in three perovskite materials—NH₃CH₃PbI₃ (MAPbI₃), NH₃CH₃PbBr₃ (MAPbBr₃), and CsPbBr₃—during microwave photoconductivity decay (μ-PCD) measurements.

3. **Improvement of carrier lifetime**: Experimental results show that for MAPbI₃ polycrystalline samples, continuous wave laser illumination can significantly extend the carrier lifetime. This effect is also observed in other samples, although to a lesser extent.

4. **Significance for solar cell design**: By mitigating carrier trap effects, it is possible to more accurately estimate the carrier lifetime of perovskite-based devices under actual working conditions, which is crucial for optimizing the design of perovskite solar cells.