Abstract:The rational design and preparation of bifunctional electrocatalysts with high catalytic performance for oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) are extremely crucial for the development of fuel cells and regenerative metal-air cells. In this work, a simple compound-assisted pyrolyzing strategy is reported to synthesize Co-N-C (CoNC-xcompound-800) materials by high-temperature annealing of ZIF-12. Results show that the physicochemical properties of the obtained CoNC-xcompound-800 are dependent on the type of the assistant compound. With the introduction of organic compound (i.e., C3H6N6, C6H14O6, C16H32O2, CH3(CH2)16COOH, C6H5NO3), the specific surface area, the carbon defect content, the content of pyridinic-N and graphitic-N, and the Co-Nx concentration of the obtained CoNC-0.5compound(organic)-800 are greatly increased, which result in the improved activities of the 0.5compound(organic)-800 samples. Differently, with the addition of inorganic compound (i.e., Na3PO4, KCl, K2CO3), the carbon defect content, the content of pyridinic-N and graphitic-N, and the Co-Nx concentration of the obtained CoNC-0.5compound(inorganic)-800 are greatly decreased, which lead to reduced activities of the 0.5compound(inorganic)-800 samples. Among these materials, the CoNC-0.5C6H14O6-800 shows satisfactory ORR performance with a half-wave potential of 0.89 V. Meanwhile, CoNC-0.5C6H14O6-800 exhibits an optimal OER performance with an overpotential being only 425 mV at current density of 10 mA cm−2. Our work provides a simple and universal method to adjust the physicochemical properties of the ZIF-12-derived Co-N-C materials. Besides, the results demonstrate that optimal pore structure, higher carbon defect content, higher content of pyridinic-N and graphitic-N, and higher Co-Nx concentration are of great importance for the improvement of the electrochemical performances of the Co-N-C catalysts.

Engineering Strategy for Enhancing the Co Loading of Co-N 4 -C Single-Atomic Catalysts Based on the ZIF-67@Yeast Construction

Boosting Electrocatalytic Activity of Single Atom Catalysts Supported on Nitrogen‐Doped Carbon through N Coordination Environment Engineering

Cobalt Single Atom Anchored on N-doped Carbon Nanoboxes As Typical Single-Atom Catalysts (sacs) for Boosting the Overall Water Splitting

Cascade Anchoring Strategy for General Mass Production of High-Loading Single-Atomic Metal-Nitrogen Catalysts.

Engineering the morphology and electronic structure of atomic cobalt-nitrogen-carbon catalyst with highly accessible active sites for enhanced oxygen reduction

Atomic Evolution of Metal–Organic Frameworks into Co–N3 Coupling Vacancies by Cooperative Cascade Protection Strategy for Promoting Triiodide Reduction

Strategic Defect Engineering of Metal–Organic Frameworks for Optimizing the Fabrication of Single‐Atom Catalysts

Decarboxylation-Induced Defects in MOF-Derived Single Cobalt Atom@Carbon Electrocatalysts for Efficient Oxygen Reduction

Defect Engineering of High-Loading Single-Atom Catalysts for Electrochemical Carbon Dioxide Reduction

Gas Diffusion Strategy for Inserting Atomic Iron Sites into Graphitized Carbon Supports for Unusually High‐Efficient CO2 Electroreduction and High‐Performance Zn–CO2 Batteries

Design of Atomically Dispersed CoN4 Sites and Co Clusters for Synergistically Enhanced Oxygen Reduction Electrocatalysis

Engineering Local and Global Structures of Single Co Atoms for a Superior Oxygen Reduction Reaction

Coordinatively Unsaturated Single Co Atoms Immobilized on C 2 N for Efficient Oxygen Reduction Reaction

High-Density Cobalt Single-Atom Catalysts for Enhanced Oxygen Evolution Reaction

Standing Carbon‐Supported Trace Levels of Metal Derived from Covalent Organic Framework for Electrocatalysis

Fabrication of Single-Atom Catalysts with Precise Structure and High Metal Loading

Structure optimization of ZIF-12-derived Co-N-C for efficient oxygen reduction and oxygen evolution

High‐Loading Co Single Atoms and Clusters Active Sites toward Enhanced Electrocatalysis of Oxygen Reduction Reaction for High‐Performance Zn–Air Battery

Cascade Anchoring Strategy for Fabricating High-Loading Pt Single Atoms as Bifunctional Catalysts for Electrocatalytic Hydrogen Evolution and Oxygen Reduction Reactions

Constructing High-Loading Single-Atom/Cluster Catalysts Via an Electrochemical Potential Window Strategy

MOF Structure Engineering to Synthesize CoNC Catalyst with Richer Accessible Active Sites for Enhanced Oxygen Reduction