Effect of hafnium and molybdenum addition on inclusion characteristics in Co-based dual-phase high-entropy alloys

Yong Wang,Wei Wang,Joo Hyun Park,Wangzhong Mu

DOI: https://doi.org/10.1007/s12613-024-2831-x

2024-05-29

International Journal of Minerals Metallurgy and Materials

Abstract:Specific grades of high-entropy alloys (HEAs) can provide opportunities for optimizing properties toward high-temperature applications. In this work, the Co-based HEA with a chemical composition of Co 47.5 Cr 30 Fe 7.5 Mn 7.5 Ni 7.5 (at%) was chosen. The refractory metallic elements hafnium (Hf) and molybdenum (Mo) were added in small amounts (1.5at%) because of their well-known positive effects on high-temperature properties. Inclusion characteristics were comprehensively explored by using a two-dimensional cross-sectional method and extracted by using a three-dimensional electrolytic extraction method. The results revealed that the addition of Hf can reduce Al 2 O 3 inclusions and lead to the formation of more stable Hf-rich inclusions as the main phase. Mo addition cannot influence the inclusion type but could influence the inclusion characteristics by affecting the physical parameters of the HEA melt. The calculated coagulation coefficient and collision rate of Al 2 O 3 inclusions were higher than those of HfO 2 inclusions, but the inclusion amount played a larger role in the agglomeration behavior of HfO 2 and Al 2 O 3 inclusions. The impurity level and active elements in HEAs were the crucial factors affecting inclusion formation.

materials science, multidisciplinary,metallurgy & metallurgical engineering,mining & mineral processing

What problem does this paper attempt to address?

The paper aims to study the effects of adding hafnium (Hf) and molybdenum (Mo) on the characteristics of inclusions in Co-based high-entropy alloys (HEAs). Specifically:

1. **Changes in Inclusion Characteristics**:
- The paper selected a Co-based high-entropy alloy with a chemical composition of Co47.5Cr30Fe7.5Mn7.5Ni7.5 and added small amounts of hafnium (Hf) and molybdenum (Mo) to study the effects of these elements on the characteristics of inclusions.
- The study found that adding Hf can reduce the number of Al2O3 inclusions and lead to the formation of more stable Hf-enriched inclusions as the primary phase.
- Adding Mo does not affect the type of inclusions but influences the characteristics of inclusions by changing the physical parameters of the alloy melt.

2. **Theoretical Analysis of Inclusion Behavior**:
- Using thermodynamic calculation methods, the study investigated the formation possibilities and stability of different inclusions (such as Al2O3, HfO2, and MnS) in different alloys.
- The results show that HfO2 inclusions are more likely to form than Al2O3 over the entire temperature range, consistent with previous research findings that the oxidation energy of Hf is lower than that of Al.

3. **Nucleation, Growth, and Collision Behavior of Inclusions**:
- The paper also explored the nucleation, growth, and collision behavior of different inclusions (such as Al2O3, HfO2, and MnS) in the alloy melt.
- The study found that HfO2 inclusions can nucleate uniformly at lower supersaturation, whereas Al2O3 inclusions require higher supersaturation.

Through the above research, the paper provides fundamental data and technical support for the future preparation of high-entropy alloys with different compositions.