Abstract:A detailed petrographic, structural and morphometric investigation of different types of caves carved in the quartz–sandstones of the “tepui” table mountains in Venezuela has allowed identification of the main speleogenetic factors guiding cave pattern development and the formation of particular features commonly found in these caves, such as funnel-shaped pillars, pendants and floor bumps. Samples of fresh and weathered quartz–sandstone of the Mataui Formation (Roraima Supergroup) were characterised through WDS dispersive X-ray chemical analyses, picnometer measurements, EDAX analyses, SEM and thin-section microscopy. In all the caves two compositionally different strata were identified: almost pure quartz–sandstones, with content of silica over 95% and high primary porosity (around 4%), and phyllosilicate-rich quartz–sandstone, with contents of aluminium over 10% and low primary porosity (lower than 0.5%). Phyllosilicates are mainly pyrophyllite and kaolinite. SEM images on weathered samples showed clear evidence of dissolution on quartz grains to different degrees of development, depending on the alteration state of the samples. Grain boundary dissolution increases the rock porosity and gradually releases the quartz grains, suggesting that arenisation is a widespread and effective weathering process in these caves. The primary porosity and the degree of fracturing of the quartz–sandstone beds are the main factors controlling the intensity and distribution of the arenisation process. Weathering along iron hydroxide or silt layers, which represent inception horizons, or a strata-bounded fracture network, predisposes the formation of horizontal caves in specific stratigraphic positions. The loose sands produced by arenisation are removed by piping processes, gradually creating anastomosing open-fracture systems and forming braided mazes, geometric networks or main conduit patterns, depending on the local lithological and structural guidance on the weathering process. This study demonstrates that all the typical morphologies documented in these quartz–sandstone caves can be explained as a result of arenisation, which is guided by layers with particular petrographic characteristics (primary porosity, content of phyllosilicates and iron hydroxides), and different degrees of fracturing (strata-bounded fractures or continuous dilational joints).

Physical constraints on speleothem deformations caused by earthquakes, seen from a new perspective: Implications for paleoseismology

Stability Analysis of Jointed Rock Mass in Large Underground Caverns Based on Multi-Scale Analysis Method

Seismic responses of the densely distributed caves of the Mogao Grottoes in China

A Comprehensive Seismic Monitoring of the Pillar Threatening the World Cultural Heritage Site Chauvet‐Pont d'Arc Cave, Toward Rock Damage Assessment

Role of hydro-mechanical coupling in excavation-induced damage propagation, fracture deformation and microseismicity evolution in naturally fractured rocks

Structural and lithological guidance on speleogenesis in quartz–sandstone: Evidence of the arenisation process

Mechanical response and failure pattern of a modified mixed compression-shear experiments based on acoustic emission and numerical simulation

Stress wave propagation and incompatible deformation mechanisms in rock discontinuity interfaces in deep-buried tunnels

Integrated Geophysical and Geomorphological Studies of Caves in Calcarenite Limestones (Jaskinia pod Świecami Cave, Poland)

Description of seismic sources in underground mines: Dynamic stress fracturing around tunnels and strainbursting

Dynamic Responses of U-Shaped Caverns under Transient Stress Waves in Deep Rock Engineering

Crosshole Seismic CT Data Field Experiments and Interpretation for Karst Caves in Deep Foundations

The influence of environmental humidity change on the stability of rock caves in Longyou Grottoes

Temperature fluctuations and ventilation dynamics induced by atmospheric pressure variations in Lamalunga Cave (Apulia, Italy) and their influences on speleothem growth

Mechanical Response of Surrounding Rock of Karst Tunnel under Stress-Damage-Seepage Coupling Effect

Experimental exploration of damage propagation in rocks using acoustic emission

Effect of Multiscale Cracks on Seismic Wave Propagation in Tight Sandstones

Influence of the Seismic Wave Velocity of the Damage Zone on Near-Field Ground Motions

Seismic Moment and Recurrence: Microstructural and mineralogical characterization of rocks in carbonate fault zones and their potential for luminescence and ESR dating

Three-dimensional (3D) dynamic finite element modeling of the effects of a geological fault on the seismic response of underground caverns

Numerical studies on micro-cracking behavior of transversely isotropic argillaceous siltstone in Longyou Grottoes under three-point bending