Abstract:A novel series of linear, high molecular weight aromatic copolymers containing trifluoromethyl and dimethylamino groups was synthesized via facile super-acid catalyzed polyhydroxyalkylation and investigated as CO 2 gas separation membrane materials. The molar ratio of the two ketone comonomers used in copolymerization, trifluoroacetophenone (TFAp) and N,N-dimethylamino trifluoroacetophenone (dMATFAp), was systematically varied to produce five copolymers with different dMATFAp contents ranging from 12 to 73 %. The influence of dMATFAp content on physicochemical and mechanical properties as well as pure gas and water vapor separation performance was studied. All synthesized copolymers displayed excellent film forming ability, high thermal stability and high T g values (T gs > 380 °C). Pure gas permeability measurements revealed that the increase of dMATFAp molar content from 12 % to 34 % resulted in improved gas permeability, while, on the contrary, further increase of dMATFAp content from 34 to 73 % led to substantial gas permeability decrease ascribed to FFV decrease. In particular, among copolymers, the one with dMATFAp content of 34 % presented the highest CO 2 permeability value of 290 Barrer due to its highest CO 2 diffusion and CO 2 solubility coefficients associated with its higher FFV value. The CO 2 /CH 4 performance of synthesized copolymers fell very close to 2008 upper bound limit and exceeded most of the super-acid catalyzed copolymer membranes reported in the literature and commercial membranes. CO 2 /CH 4 and CO 2 /N 2 selectivity values for the different synthesized copolymers were in the range of 29.9–40 and 22.7–44, respectively. The study of the effect of dMΑTFA on water permeability unveiled that the membrane with the highest dMΑTFAp molar content (73 %) showed the highest water permeability value (23,100 Barrer) as well. This was attributed to the increased concentration of N-methyl substituent of dMΑTFAp which can interact with water molecules thereby increasing solubility. Under process gas stream conditions using a mixture of 3 % H 2 O-48.5 % CO 2 -48.5 % CH 4 , both CH 4 and CO 2 permeability were significantly reduced (by 35 % and 47 %, respectively) due to the preferential sorption of water vapor over other gases present in the mixture, highlighting the negative effect of water vapor on gas permeability. Accordingly, the CO 2 /CH 4 separation factor was slightly increased from 23.8 to 29. Finally, stability test of the copolymer (BP-TFAp) 66 -(BP-dMATFAp) 34 at 40 °C under humid mixed gas conditions showed that CO 2 and CH 4 permeability remained unchanged for one month after an initial condition stabilization that is required implying that these copolymer structures are promising materials for CO 2 separation.

Synthesis of polyimides containing Tröger's Base and triphenylmethane moieties with tunable fractional free volume for CO 2 separation

Acetate-Functional Thermally Rearranged Polyimides Based on 2,2-Bis(3-amino-4-hydroxyphenyl)hexafluoropropane and Various Dianhydrides for Gas Separations

Synthesis, characterization, and gas separation properties of novel fluorinated co-polyimides with bulky side groups

Synthesis and gas separation properties of polyimide membranes derived from oxygencyclic pseudo-Tröger's base

Synthesis of new copolyimides containing pyridine and morpholine groups for gas separation through molecular design and simulation

Structural engineering on copolyimide membranes for improved gas separation performance

Development of Phenolphthalein-Based Copolyimides and their Derivative Cross-Linked and Thermally Rearranged Polymers for Gas Separation

Highly Selective Benzimidazole-Based Polyimide/Ionic Polyimide Membranes for Pure- and Mixed-Gas CO2/CH4 Separation

Intrinsically microporous polyimide membranes with synergistic aromatic and alicyclic linking groups for efficient molecular separation

Preparation and characterization of highly heat-resistant, soluble, and hydrophobic fluorinated polyimides with gas transport properties

Synthesis and gas separation performances of intrinsically microporous polyimides based on 4-methylcatechol-derived monomers

Tuning free volume for enhanced gas separation by introducing fluorinated aryl ether diamine moiety in Tröger's-based membranes

Intrinsically Microporous Polyimides Derived from 2,2′-Dibromo-4,4′,5,5′-bipohenyltetracarboxylic Dianhydride for Gas Separation Membranes

Constructing Thin and Cross-Linked Polyimide Membranes by Interfacial Reaction for Efficient CO 2 Separation

Enhancing gas separation performance of polyimide with Tröger's bases: Unveiling the impact on polymer and carbon molecular sieve membranes

Finely tuning the microporosity in dual thermally crosslinked polyimide membranes for plasticization resistance gas separations

Interfacial polymerization of COF-polyamide composite membranes modified with ionic liquids for CO 2 separations

Synthesis of fluorinated ether free aromatic backbone copolymers containing trifluoromethyl and dimethylamino groups for CO 2 separation: Investigation of pure and mixed gas performance under dry and humid conditions

Aromatic Polyimide Membranes with tert-Butyl and Carboxylic Side Groups for Gas Separation Applications—Covalent Crosslinking Study

Enhanced polyphosphazene membranes for CO2/CH4 separation via molecular design

Mechanical, thermal and gas separation properties of copolyimides and their thermal rearrangement copolymer membranes with spirobisindane structures