Additional Reference Height Error Analysis for Baseline Calibration Based on a Distributed Target DEM in TwinSAR-L

Yang Qi,Yu Wang,Jun Hong,Shaoyan Du
DOI: https://doi.org/10.3390/rs13142750
IF: 5
2021-07-13
Remote Sensing
Abstract:In this paper, additional reference height errors, caused by the penetration depth and Signal to Noise Ratio (SNR) decorrelation in desert regions in L-band spaceborne bistatic interferemetric SAR, will introduce significant errors in nowadays baseline calibration method based on distributed target and consequent DEM products. To quantify these two errrors, this paper takes the TwinSAR-L mission as an example, gives an introduction of TwinSAR-L, outlines the theoretical baseline accuracy requirements that need to be satisfied in the TwinSAR-L mission and addresses the additional reference height errors caused by the penetration depth and SNR decorrelation in desert regions in general by taking the TwinSAR-L mission as an example. Based on ALOS-2 data from a dry desert region in the east of Xing Jiang, this paper quantitatively analyzes these additional reference height errors. The results show that the additional reference height errors resulted from the penetration depth and the SNR decorrelation are 1.295 m and 1.39 m, respectively, which would even cause 6.4 mm and 8.6 mm baseline calibration errors. These errors would seriously degrade the baseline calibration accuracy and the consequent DEM product quality. Therefore, our analysis is of great significance not only for baseline calibration, but also for high-quality DEM’s generation, accuracy assessment and geophysical parameters’ quantitative inversion and application.
environmental sciences,imaging science & photographic technology,remote sensing,geosciences, multidisciplinary
What problem does this paper attempt to address?