Abstract:Plasma response to 3D resonant magnetic perturbations (RMPs), applied for the purpose of controlling type-I edge localized modes (ELMs) in ITER with the baseline ELM control coils, is computed using a toroidal, resistive, full magneto-hydrodynamic model. Considered are five representative ITER plasmas, designed for different phases of the ITER exploration. The plasma response, measured by the plasma boundary corrugation, is found to be similar for the two DT scenarios at full plasma current (15 MA) and full toroidal field (5.3 T) but different fusion gain factors (Q = 5 versus Q = 10), indicating similar ELM control performance with the same RMP coil current configuration. The other plasma scenarios, with proportionally scaled down plasma current and toroidal field, can have different plasma boundary corrugation. The key plasma parameter affecting the response is the plasma toroidal flow near the pedestal region, which significantly varies depending on the transport model assumption for the toroidal momentum. Lower pedestal flow leads to a stronger edge peeling response from the plasma and thus probably a better ELM control. The optimal coil configuration for controlling type-I ELMs is similar for all four ITER plasmas with similar safety factor but different current levels, but is significantly different for the case at half plasma current (7.5 MA) and full field (5.3 T). On the other hand, for the purpose of controlling the radial profile of the plasma toroidal rotation in ITER using 3D fields, the relative amplitude of the toroidal torque density, between the plasma core and edge region, is optimized. Generally, a strong coupling between the core and edge torques is observed, largely due to the middle row ELM control coils. The best decoupling scheme of the core-edge torque distribution thus de-emphasizes the role of the middle row coils. Optimal coil current configurations are found for the ITER 15 MA/5.3 T Q = 10 plasma, that synergistically maximize the plasma edge-peeling response (indication for good ELM control) and the toroidal torque near the plasma edge (good for RMP field penetration through pedestal).

Effective Evaluation of the Impact of the Magnetic Ripple on the Field Line Topology in DTT: Preliminary Results

Closed-Loop Tracking Control Of Poloidal Magnetic Flux Profile In Tokamaks

Turbulent features near the X point of a DTT-like tokamak plasma

Magnetic control of DTT alternative plasma configurations

Ripple effect and impact of test blanket module by using RAFM steels on the plasma of ITER

First principle-based multi-channel integrated modelling in support of the design of the Divertor Tokamak Test facility

Kinetic modeling of the plasma-wall interaction in the DTT divertor region

Modelling of spatial structure of divertor footprints caused by edge-localized modes mitigated by magnetic perturbations

On the edge turbulence in a DTT-like tokamak plasma

Time-dependent full-radius integrated modeling of the DTT tokamak main plasma scenarios

Separating the roles of magnetic topology and neutral trapping in modifying the detachment threshold for TCV

Dynamic Divertor Control Using Resonant Mixed Toroidal Harmonic Magnetic Fields During ELM Suppression in DIII-D

Modeling 3D Plasma Boundary Corrugation and Tailoring Toroidal Torque Profiles with Resonant Magnetic Perturbation Fields in ITER

Exploration of Non-Resonant Divertor Features on the Compact Toroidal Hybrid

Primary Quench Detection Analysis for the EU-DEMO Toroidal Field Coils

Inferring the scrape-off layer heat flux width in a divertor with a low degree of axisymmetry

First-principle based predictions of the effects of negative triangularity on DTT scenarios

Conceptual Design of In-Vessel Divertor Coils in DTT

Toroidal Field Analysis of the J-TEXT Tokamak

Small resonant magnetic perturbations result in three-dimensional material transport in the fusion plasma edge

Multifield Measurement of Magnetic Fluctuation-Induced Particle Flux in a High-Temperature Toroidal Plasma