Abstract:High entropy alloys (HEA) are complex multi-element materials. Owing to their multi-elemental nature, they can finetune surface adsorption energy and active sites which make them appealing to various catalytic reactions. HEI is a subclass of HEA that consist of an ordered alloy structure rather than a random alloy structure. The order-ness may induce more stable structures and uniform active sites, which in turn enhance the durability and activity under catalytic conditions. Here, we have synthesized a HEI(Pt 40 Ni 20 Co 20 Mn 10 Ir 10 ) supported on porous carbon via a seed-mediated impregnation method. The intermetallic characteristics with periodic trends can be seen in the HAADF-STEM image (Fig. 1a). Based on the atomic arrangement, the HEI resembled a L1 2 structure. The corresponding EDX mapping the catalyst also showed the presence of all alloying species in the nanoparticles. The catalyst performance of the catalysts was evaluated in a 3-electrode liquid cell set-up with catalyst coated glassy carbon rotating disk electrode, Ag/AgCl and Pt mesh as working, reference and counter electrode, respectively. The catalyst’s mass activity (MA) was calculated based on the result obtained from ORR polarization test conducted under O 2 saturated 0.1M HClO 4 . The initial mass activities for PtCo and HEA in ORR were 0.81 and 1.23 A mg -1 Pt , respectively (Fig. 1b), while that of Pt/C was only 0.26 A mg -1 Pt . A subsequent accelerated degradation test (ADT) was conducted under Ar-saturated 0.1M HClO 4 with 0.6-1.0 V vs RHE square-wave cycling (3s hold at each potential) for 30k cycles. MA was measured after 10k and 30k cycles. HEA retained a MA of 0.48 A mg -1 Pt after the ADT, above the DOE target (0.44 A mg -1 Pt ). We also compared our HEI samples synthesized with different annealing temperatures and duration (Fig. 1c), and it showed that 800 ◦ C with 20 mins temperature hold showed the highest MA and electrochemical surface area (ECSA). Extended X-ray absorption spectroscopy (EXAFS) for the catalyst has also been conducted to further elucidate the structural-performance relationship of HEI (Fig.1d). From Pt L3 edge EXAFS fitting, the fitted R space showed that the Pt-Pt bond length was around 2.704 ± 0.004 Å, which was same as that of the PtCo (Fig. 1e). Therefore, it is believed that both HEI and PtCo has the same strain effect but HEI possessed stronger ligand effect than PtCo due to its unique Pt-M coordination, hence resulting in superior ORR performance over PtCo and Pt. Figure 1

Flame Spray Pyrolysis Synthesis of Ultra‐Small High‐Entropy Alloy‐Supported Oxide Nanoparticles for CO2 Hydrogenation Catalysts

Hydrogen spillover-driven synthesis of high-entropy alloy nanoparticles as a robust catalyst for CO2 hydrogenation

High-Entropy Alloy Al0.2Co1.5CrFeNi1.5Ti0.5 Prepared from High-Entropy Oxide (Al0.2Co1.5CrFeNi1.5Ti0.5)3O4 by a Deoxidation Process via a CaH2-assisted Molten Salt Method

The Micron-Droplet-Confined Continuous-Flow Synthesis of Freestanding High-Entropy-Alloy Nanoparticles by Flame Spray Pyrolysis

Recent Progress in High‐entropy Nanocatalysts

Scalable synthesis of nanoporous high entropy alloys for electrocatalytic oxygen evolution

Synthesis of high-entropy alloy nanoparticles on supports by the fast moving bed pyrolysis

Noble-Metal-Free High-Entropy Alloy Nanoparticles for Efficient Solar-Driven Photocatalytic CO2 Reduction

Heterogeneous high-entropy catalyst nanoparticles for oxygen evolution reaction: Impact of oxygen and fluorine introduction

Transient synthesis of carbon-supported high-entropy alloy sulfide nanoparticles via flash Joule heating for efficient electrocatalytic hydrogen evolution

Carbothermal Shock Synthesis of High Entropy Oxide Catalysts: Dynamic Structural and Chemical Reconstruction Boosting the Catalytic Activity and Stability toward Oxygen Evolution Reaction

A general method to synthesize high-entropy oxide nanoparticles by low-energy-recoil ion implantation for efficient oxygen evolution reaction

High‐entropy Alloy Aerogels: A New Platform for Carbon Dioxide Reduction

Atomic Structure Amorphization and Electronic Structure Reconstruction of FeCoNiCrMox High‐Entropy Alloy Nanoparticles for Highly Efficient Water Oxidation

Rapid High-Temperature Liquid Shock Synthesis of High-Entropy Alloys for Hydrogen Evolution Reaction.

Synergistic Effects of PtRhNiFeCu High Entropy Alloy Nanocatalyst for Hydrogen Evolution and Oxygen Reduction Reactions.

In Situ, Rapid Synthesis of Carbon‐Loaded High Density and Ultrasmall High Entropy Oxide Nanoparticles as Efficient Electrocatalysts

Rapid synthesis of an OER catalytic surface on dual-phase high-entropy alloys via a controllable single-phase corrosion approach

High-Entropy Alloys as Oxygen Reduction Reaction Electrocatalysts for Proton Exchange Membrane Fuel Cells Application

Polymer‐Confined Pyrolysis Promotes the Formation of Ultrafine Single‐Phase High‐Entropy Alloys: A Promising Electrocatalyst for Oxidation of Nitrogen