Abstract:A heat-generating surface with multiple heat sources is frequently encountered in modern power electronic devices. Efficient cooling techniques are especially needed to prevent the overheating of these devices, so as to avoid consequences like performance deterioration, failure rate increase, reduced lifetime and safety threats. The main objective of this study is to design and optimize the structure of heat sinks for single-phase convective cooling of a heat-generating surface under multiple-peak heat flux. In particular, a genetic algorithm-based topology optimization (GATO) method has been developed and tested for this purpose. The middle area of heat sink receiving heat flux is treated as the design domain and represented as a binary matrix ( Mrow×column ). Each element in the matrix is considered either as fluid or as solid, and their allocation is optimized to minimize the peak temperature ( T peak ) at the heating surface of the heat sink under the constraint of constant void volume for the fully-connected fluid domain. For each optimization step, the fluid flow and temperature characteristics are obtained by CFD simulation using OpenFoam, which are then used for GA operations (selection, crossover, mutation, etc.). The impacts of design and operation parameters on the optimized global flow channel configuration are evaluated, including the heat flux shape, the fluid void fraction, the inlet velocity, and the resolution of the design domain. Results obtained show that: (1) the proposed GATO method could successfully determine the optimal flow channel configuration of the heat sink, minimizing the T peak at the heating surface; (2) The obtained optimal configuration depends on the design and operating parameters while the effectiveness and robustness of the GATO method are verified; (3) Compared to conventional straight channel heat sink, the GATO heat sink could always achieve a better cooling performance under the same working condition, with a reasonable and acceptable increase of the pressure drop. The method developed in this study could be a useful contribution to the TO of heat sinks/exchangers with demonstrated potential in engineering thermal design and optimization.

Data-Driven Design for Targeted Regulation of Heat Transfer in Carbon/Carbon Composite Structure

Data-Driven Design of Thermal-Mechanical Multifunctional Metamaterials

Optimization Strategy for Curing Ultra-Thick Composite Laminates Based on Multi-Objective Genetic Algorithm

Optimization and thermal-performance deep learning on carbon/epoxy composite panels with microchannel structure for battery cooling

Self-adaptive Passive Temperature Management for Silicon Chips Based on Near-Field Thermal Radiation

Machine Learning for 3D-IC Electric-Thermal Simulation and Management

A Heat-Balance Method for Autoclave Process of Composite Manufacturing

Two-scale data-driven design for heat manipulation

Algorithmic and Simulated Based Structural Optimization of Air-Cooling Heat Dissipation Structure for EV Battery Pack

Shaping Thermal Transport and Temperature Distribution via Anisotropic Carbon Fiber Reinforced Composites

Constructal evolutionary design of liquid cooling heat sink embedded in 3D-IC based on deep neural network prediction

Intelligent design of thermal metamaterials based on deep learning assisted structure optimization

Optimal design of finned surface structures to reduce thermal contact resistance

A computational model of an air-layer radiant cooling panel for optimizing and design

Deep Learning‐Assisted Active Metamaterials with Heat‐Enhanced Thermal Transport

Deep learning-assisted active metamaterials with heat-enhanced thermal transport

Employment of 3D-Printed Bilayer Structures with Embedded Continuous Fibers for Thermal Management Applications: An Axial Cooling 4D-Printed Fan Application Case Study

Optimization of Thermal Management for the Environmental Worthiness Design of Aviation Equipment Using Phase Change Materials

Regulatable Orthotropic 3D Hybrid Continuous Carbon Networks for Efficient Bi-Directional Thermal Conduction

A genetic algorithm-based topology optimization (GATO) method for convective cooling of a heating surface with multiple heat sources

Co-enhancement of Thermal Conduction and Radiation Through Morphologies Controlling of Graphene Functional Layer for Chip Thermal Management