Abstract:Experiments were conducted to study the relationship between the transmission ratio (TR) and normal stress, joint roughness, joint number and frequency of incident waves, respectively, when ultrasonic waves pass across a rock mass with one joint and multiple parallel joints oriented normally. The ultrasonic waves were generated and received by pairs of piezoelectric transducers and recorded by an ultrasonic detector. The specimens were subjected to normal stress by a hydraulic jack and loading frame. The jointed rock mass was produced by superposing rock blocks in the study. Rough joints were produced by grooving notches on the planar joints formed by sawing directly. In the case of multiple parallel joints, the overall thickness of specimens was maintained while the joint number changed. Three pairs of P-wave transducers and one pair of S-wave transducers with different frequencies were, respectively, applied and all transducers emitted signals perpendicular to the joints in the experiment. The results indicate that TR increases with increasing normal stress while the increment rate decreases gradually. This is particularly so when the normal stress is high enough that TR will approximate 1 even if the rock mass has many joints. In addition, the experiments indicate that the higher the wave’s frequency, the lower its TR, and this phenomenon is gradually reduced as the normal stress increases. In response to S-waves, TR increases with increase in joint roughness; however, in response to P-waves, TR decreases gradually with increase in joint roughness. For multiple parallel joints in a fixed thickness rock mass with normally incident P-waves, TR does not always decrease with increase in the number of joints, and there is a threshold joint spacing for a certain incident wave: when the joint spacing is smaller than the threshold value, TR will increase with a decrease in joint spacing. The experimental results support similar conclusions based on analytical results drawn by Cai and Zhao (Int J Rock Mech Min Sci 37(4):661–682, 2000), Zhao et al. (Int J Rock Mech Min Sci 43(5):776–788, 2006b) and Zhu et al. (J Appl Geophys 73:283–288, 2011a).

Transmission and application of a P-wave across joints based on a modified g- λ model

Vibration of layered saturated ground with a tunnel subjected to an underground moving load

Damage Evolution of Rocks Containing a Set of Cross-Joints Based on Acoustic Emission Characteristics

Experimental Study of Ultrasonic Waves Propagating Through a Rock Mass with a Single Joint and Multiple Parallel Joints

The Influence of a Neighboring Tunnel on the Critical Velocity of a Three-Dimensional Tunnel-Soil System

Transmission Law of Nonlinear Wave Across Jointed Rock

The Wave Function Method for Calculation of Vibrations from a Twin Tunnel in a Multi-Layered Half-Space

Experimental and theoretical study on the propagation characteristics of stress wave in filled jointed rock mass

Analytical Wave Function Method for Modelling a Twin Tunnel Embedded in a Saturated Poroelastic Full-Space

Numerical Analysis of Mechanical Response Characteristics of Jointed Tunnel Surrounding Rock under Dynamic Loading

Wave propagations in crossing-fault tunnels and their effects on the dynamic response characteristics of tunnel surrounding rock

A modified displacement discontinuity method for seismic wave propagation across rock masses with thin-layer joints

Wave propagation across rock joints filled with viscoelastic medium using modified recursive method

Analytical Study Of S-Wave Propagation Across Saturated Joints In Rock Masses

Analytical Methods For Wave Propagation Across Jointed Rock Masses

Model test study on the dynamic failure process of tunnel surrounding rocks in jointed rock mass under explosive load

A Novel Dual-Scale Equivalent Model for Analyzing the Frequency Response of Wave Propagation in Jointed Rock Mass

Dynamic failure mechanism of tunnel under rapid unloading in jointed rockmass: A case study

Response and failure mechanism of utility tunnel with flexible joints under reverse fault: An experimental, numerical, and analytical investigation

P-wave transmission across fractures with nonlinear deformational behaviour

Mechanical response of tunnels crossing active fault zones under normal or reverse faulting: A refined nonlinear analytical approximate solution