Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

A dynamic visualization based on conceptual graphs to capture the knowledge for disaster education on floods

Multilevel data simplification methods for flood process visualizations based on visual perceptions

A GIS-based 3D Visual Simulation System for Flood Protection

Visualization and Damage Assessment for Flooded Area

An augmented representation method of debris flow scenes to improve public perception

An efficient flood dynamic visualization approach based on 3D printing and augmented reality

A knowledge-guided visualization framework of disaster scenes for helping the public cognize risk information

AN INTERACTIVE EVACUATION TOOL TO IMPROVE THE PUBLIC FLOOD PERCEPTION

A flood knowledge-constrained large language model interactable with GIS: enhancing public risk perception of floods

A 3D virtual geographic environment for flood representation towards risk communication

RESEARCH ON THE CONSTRUCTION OF GEOGRAPHIC KNOWLEDGE GRAPH INTEGRATING NATURAL DISASTER INFORMATION

From data to action in flood forecasting leveraging graph neural networks and digital twin visualization

Real-Time Visualization of Urban Flood Simulation Data for Non-Professionals

Urban flood vulnerability Knowledge-Graph based on remote sensing and textual bimodal data fusion

Dynamic 3D Simulation of Flood Risk Based on the Integration of Spatio-Temporal GIS and Hydrodynamic Models

Knowledge Visualization: An Effective Way of Improving Learning

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

Enabling Quick, Accurate Crowdsourced Annotation for Elevation-Aware Flood Extent Mapping

A GIS Based Model for Calculating of Flood Area

A Parallel Computation and Web Visualization Framework for Rapid Large-scale Flood Risk Mapping