Discrepancies in using CO2 or water as heat-carrier fluid on the output temperature of deep coaxial borehole heat exchanger

Mengmeng Bai,Fenghao Wang,Jun Liu,Wanlong Cai,Zhihua Wang
DOI: https://doi.org/10.1016/j.enbuild.2022.112279
IF: 7.201
2022-09-01
Energy and Buildings
Abstract:Conventional deep coaxial borehole heat exchanger (DCBHE) may experience notable discrepancies with water or CO2 as heat-carrier fluid. In this paper, a numerical model was established by considering the temperature-dependent properties of CO2 and water. The model's effectiveness was validated against the demonstration project and fit the demonstrated data. The results indicating that the suitable inlet pressure of CO2 under benchmark condition was determined to be 10 MPa, the output CO2 temperature in DCBHE was high and fluctuated from 42°C to 44°C in a supercritical state. With respect to heat transfer rate varying from 80 W/m to 120 W/m and inlet velocity changing from 0.5 m/s to 0.9 m/s, it was recommended to select CO2 as heat-carrier fluid with inlet pressure of 10 MPa, and water as the heat carrier fluid with inlet pressure of 15 MPa when the depth of DCBHE was 2500 m. In terms of depth lengthening from 2000 m to 3500 m under the benchmark conditions, selecting water as the heat carrier fluid with inlet pressure of 15 MPa was suggested. And choosing water as heat-carrier fluid with inlet pressure of 10 MPa was proposed only when the depth was 2000 m and 3500 m. The findings answered the choices of using CO2 or water as heat-carrier fluid of DCHBE and achieve a mini step in the precise design of DCBHE in ground source heat pump systems.
energy & fuels,construction & building technology,engineering, civil
What problem does this paper attempt to address?