Abstract:The geometric complexity and high-pressure gradients that characterize the design of the flow field of gear pumps make it very difficult to obtain an accurate CFD simulation of the component. Usually, assumptions are made both in terms of geometrical features and physics being included in the analysis. The contact between the teeth, which is a key factor for the correct functioning of these pumps, represents a critical challenge in 3D CFD simulations, mainly due to the intrinsic limits of the dynamic meshing techniques that can hardly effectively manage a zero or close to zero gap point forming during gear rotation. The geometric complexity and high-pressure gradients that characterize the gear pump flow field make a CFD analysis quite difficult, and the contact between the gear teeth is usually avoided, thus being an extremely important feature. In this paper, a gear pump composed of inlet and outlet pipes was considered, and the contact between the gear’s teeth was modeled in two different ways, one where it is effectively implemented and one where it is avoided using distancing and a proper casing modification. Herein, a new methodology is proposed for the application of the dynamic mesh method in the Simcenter STAR-CCM+ environment using an adaptive remeshing technique. The proposed methodology is compared with the alternative overset meshing method available in the software. The new meshing method is implemented using a user-routing that reproduces the real geometry of the gears while rotating during the pump operation, with teeth contact included. The routine is optimized in order to limit the additional computation and time needed for the remeshing process. The results that can be obtained using the two meshing approaches for the gear pump are compared in terms of computational effort and the accuracy of the results. The two methods showed opposite results in almost all the reported results, with the overset being more precise in the radial pressure evaluation and the dynamic being more reliable in the cavitation/aeration extension cloud.

DETERMINING OPTIMAL SIMULATION SETTINGS FOR THE CENTRIFUGAL PUMP PARTS OPTIMIZATION PROCESS

Multi-Objective Optimization of Multistage Centrifugal Pump Based on Surrogate Model

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Centrifugal Pump Design: An Optimization

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Optimization of Ansys CFX Input Parameters for Numerical Modeling of Pump Performance in Turbine Operation

Automatic optimization of centrifugal pump based on adaptive single-objective algorithm and computational fluid dynamics

The Optimization of A Low Specific Speed Pipeline Pump

Multi-objective Optimization of a Low Specific Speed Centrifugal Pump Using an Evolutionary Algorithm

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct

Energy Saving Design and Operational Optimization of Centrifugal Pump Network: A Review

Performance Optimization of High Specific Speed Centrifugal Pump Based on Orthogonal Experiment Design Method

Optimization Design of Progressive Cavity Pumps via Finite Element Simulations with a Fluid-Solid Interaction Model

CFD Simulation and Optimization of semi open centrifugal pump to study axial side clearance, blade width and operating fluid effect on performance and efficiency.

CFD Analysis and Optimum Design for a Centrifugal Pump Using an Effectively Artificial Intelligent Algorithm

Mechanics mode characteristics analysis and numerical analytical optimization study of a three-stage centrifugal pump

Parametric modeling and optimization design of centrifugal pump impeller based on genetic algorithm