Abstract:One of the most important objectives in biomaterials science is the development of new materials for bone substitution. It has been found that hydroxyapatite (HAp), which is the most widely studied bioceramic, has an excellent biocompatibility and a certain degree of bioactivity [1, 2]. However, HAp is limited in its use because it is brittle compared with natural bone. In order to improve the toughness and bioactivity of bone substitution materials, biocomposites made of HAp and biocompatible organic components or bioactive glass have been developed in recent years [3-10]. Among these materials, HAp/collagen composite is of special interest because it mimics the composition of natural bone [7-10]. Preliminary study reveals that this composite has a better osteo-inductive capacity in cell culture than monolithic HAp [9]. So far, HAp/collagen composite is still at the initial stage of development. It is well known that HAp is nanometre sized and deposits in an orderly way on the collagen matrix in natural bone. However, with the synthetic methods reported, it is not easy to obtain either a uniformly mixed composite [7], or a fine crystal sized material [8-10], while these two factors are important to the bioactivity of the composite [2]. Therefore, new methods are needed to obtain an HAp/collagen composite which mimics not only the composition but also the microstructure of natural bone. This letter reports a new preparation method of HAp/ collagen composite in which nanometre sized HAp is homogeneously dispersed in collagen matrix. The results of biological testing will be published separately. Commercially purchased HAp powder and type 1 insoluble collagen from bovine achilles tendon were used as starting materials. Firstly, i g HAp was dissolved in 150 ml, 0.1 N HC1 at 20 °C and 450 mg type i collagen was added to the solution, which was then ultra-sonicated, using a Model Gl125 ultrasonator, until a thoroughly mixed slurry was obtained. Secondly, this solution was diluted to 2000 ml with distilled water, and 23.376 g NaC1 was added to increase the stability of the calcium containing solution [11]. This resulted in a 5 mM calcium solution with pH 3.0. At the third step, the solution was gently stirred at 20 °C, and 0.05 M potassium hydroxide solution was added in drops to the calcium solution to adjust the pH to 7.4. When the pH exceeded about 7.0, the solution became supersaturated and HAp started to precipitate onto the collagen. The solution was maintained at pH 7.4 for 10 min, after which the composite was harvested by centrifugation at 5000 rpm and freeze-dried. The

Bio composite of porous hydroxyapatite and collagen extracted from eggshell membrane and Oreochromis niloticus fish skin for bone tissue applications

Nano-hydroxyapatite/collagen Composite for Bone Repair

Preparation of Eggshell Derived HA-BT Composite for Biomedical Applications

Improving in Vitro Biocompatibility on Biomimetic Mineralized Collagen Bone Materials Modified with Hyaluronic Acid Oligosaccharide

A Highly Interweaved HA-SS-nHAp/collagen Hybrid Fibering Hydrogel Enhances Osteoinductivity and Mineralization

Synthesis of nanophase hydroxyapatite/collagen composite

Mineralized Collagen Based Composite for Bone Tissue Engineering

Biomimetically Mineralized Alginate Nanocomposite Fibers for Bone Tissue Engineering: Mechanical Properties and in Vitro Cellular Interactions

Synthesis and Characterization of Nano-Hydroxyapatite Obtained from Eggshell via the Hydrothermal Process and the Precipitation Method

Biomimetic Mechanically Strong One-Dimensional Hydroxyapatite/Poly( d , l -lactide) Composite Inducing Formation of Anisotropic Collagen Matrix

Biocompatibility and osteoconductivity of scaffold porous composite collagen–hydroxyapatite based coral for bone regeneration

Bio-inspired Hydroxyapatite/Gelatin Transparent Nanocomposites

Substantial effect of silk fibroin reinforcement on properties of hydroxyapatite/silk fibroin nanocomposite for bone tissue engineering application

Excellency of Hydroxyapatite Composite Scaffolds for Bone Tissue Engineering

Biomimetic Bone-Like Composite Hydrogel Scaffolds Composed of Collagen Fibrils and Natural Hydroxyapatite for Promoting Bone Repair

Magnetic and Dielectric Properties of Hybrid Nanocomposites of Biologically Extracted Hydroxyapatite/Hematite/Silicon Dioxide for Potential Use in Bone Replacement Applications

Nanocomposites of Bio-Base Polyester Containing Natural Hydroxyapatite and Duck Eggshell Made by Electrospinning: Fabrication and Characterization

Synthesis and Characterization of Poly (Ethylene Glycol) Dimethacrylate-Based Bionanocomposites with Hydroxyapatite from Rohu Fish (Labeo rohita) Bones

Preparation of Collagen/Hydroxyapatite Composites Using the Alternate Immersion Method and Evaluation of the Cranial Bone-Forming Capability of Composites Complexed with Acidic Gelatin and b-FGF

Comparison of different hydroxyapatite composites for bone tissue repair: In vitro and in vivo analyses

A 3D-Printed Polycaprolactone/Marine Collagen Scaffold Reinforced with Carbonated Hydroxyapatite from Fish Bones for Bone Regeneration