Abstract:Black liquor is a byproduct from the production of pulp and paper. Since Sweden to a large extent consists of forest it would be of great interest to use this byproduct for manufacturing of other products. Black liquor contains lignin and hemicelluloses which could be used for production of biofuel and plastics respectively. To separate these components from the black liquor, membrane filtration with ceramic membranes can be used. This study compares the efficiency of separation between ultrafiltration (UF) and nanofiltration (NF) with ultrafiltration as a pre-treatment. The results showed that a good separation of lignin and hemicelluloses from black liquor could be achieved with both methods. However, if a separation between lignin and hemicelluloses was the aim, ultrafiltration as a first step is required. The initial flux during NF increased almost 100 % (from 200 l/m 2 h to approximately 400 l/m 2 h) when the feed was permeate from ultrafiltration instead of untreated black liquor. The higher flux made it possible to reach a higher volume reduction which is desired. The results of the study show that separation of lignin and hemicellulose from black liquor is possible and that ultrafiltration as a pre-treatment has advantages compared to nanofiltration alone. Key-words: Nanofiltration, black liquor, membrane, lignin, hemicelluloses Introduction The energy demand of the world is increasing daily and today 30 % of the consumed energy is derived from fossil fuels such as oil, coal and natural gas [1]. Since the resources of these fuels will come to an end and the prices are increasing, it is important to find renewable, cheaper energy sources to meet the increasing demand [1]. Sweden is a country that is, to a large extent, covered in forest. Consequently, products from the forest industry equal 11 % of the total value of exported goods [2]. From the forest the most used raw material is wood and the largest part of the industry itself is the production of pulp and paper [3]. In the making of pulp, the wood is debarked and chopped and then fed to a digester [4]. Here, chemicals are added at a high temperature to separate the fibers from other components of the wood such as lignin, hemicelluloses and extractives [4]. From the digester two streams are obtained, of which one is rich in fibers. This stream is later washed, bleached and dried to get pulp. The other stream is black liquor [4], which is sent to a recovery boiler where the cooking chemicals are regenerated and the organic material is burnt to produce heat and power [5]. Since black liquor contains both hemicellulose and lignin which could be used to produce plastics and biofuels, a separation of this two components from the black liquor would be of interest [6]. The purpose of this study was to separate lignin and hemicelluloses from the black liquor by using membrane filtration. Materials and method Black liquor The black liquor used in this project was softwood black liquor from Södra Cell pulp mill in Mönsterås, Sweden. It was extracted directly after the digester and thus no chemicals for bleaching have been added. The composition of the black liquor used is presented in table 1. Table 1 Composition of the black liquor used. Total lignin 61,4 mg/g Acid-insoluble lignin 53,9 mg/g Acid-soluble lignin 5,03 mg/g Total dry substance 147 mg/g

Membrane processes in the separation and utilisation of wood biomass in the context of the pulp and paper industry

A biorefinery processing perspective: Treatment of lignocellulosic materials for the production of value-added products

Membrane Separations in Biomass Processing

Precipitation and separation of lignin from kraft black liquor

Pilot-scale nanofiltration and techno-economic evaluation of lignin recovery from kraft black liquor

Integration of carbon capture in a pulp mill—effect of strategic development towards better biomass resource utilization

Separation of lignin and hemicelluloses from black liquor and pretreated black liquor by nanofiltration

Enzymatic biomass utilization and modification

Recent Advancements in Lignin Valorization, Bioengineering, Catalysis and Biorefining

Electrochemical acidification of Kraft black liquor by electrodialysis with bipolar membrane: Ion exchange membrane fouling identification and mechanisms

Enzimatic Processing of Lignocellulosic Biomass for Pulp Making: A Review

Isolation of Highly Crystalline Cellulose via Combined Pretreatment/Fractionation and Extraction Procedures within a Biorefinery Concept

Microalgae-utilizing biorefinery concept for pulp and paper industry: Converting secondary streams into value-added products

Current Pretreatment Technologies for the Development of Cellulosic Ethanol and Biorefineries

An overview of lignin pathways of valorization: from isolation to refining and conversion into value-added products

Lignin recovery from spent alkaline pulping liquors using acidification, membrane separation, and related processing steps: A review

On the Effect of Hot-Water Pretreatment in Sulfur-Free Pulping of Aspen and Wheat Straw

Exploring Recent Advances in Lignocellulosic Biomass Waste Delignification Through the Combined Use of Eutectic Solvents and Intensification Techniques

Enhancing industries exploitation: Integrated and hybrid membrane separation processes applied to industrial effluents beyond the treatment for disposal

Recent Advancements and Challenges in Lignin Valorization: Green Routes towards Sustainable Bioproducts

Agricultural Residues as Raw Materials for Pulp and Paper Production: Overview and Applications on Membrane Fabrication