Abstract:High-precision mercury (Hg) stable isotopic analysis requires relatively large amounts of Hg (>10 ng). Consequently, the extraction of Hg from natural samples with low Hg concentrations (<1–20 ng/g) by wet chemistry is challenging. Combustion–trapping techniques have been shown to be an appropriate alternative [1]. Here, we detail a modified off-line Hg pre-concentration protocol that is based on combustion and trapping. Hg in solid samples is thermally reduced and volatilized in a pure O2 stream using a temperature-programmed combustion furnace. A second furnace, kept at 1,000 °C, decomposes combustion products into H2O, CO2, SO2, etc. The O2 carrier gas, including combustion products and elemental Hg, is then purged into a 40 % (v/v) acid-trapping solution. The method was optimized by assessing the variations of Hg pre-concentration efficiency and Hg isotopic compositions as a function of acid ratio, gas flow rate, and temperature ramp rate for two certified reference materials of bituminous coals. Acid ratios of 2HNO3/1HCl (v/v), 25 mL/min O2 flow rate, and a dynamic temperature ramp rate (15 °C/min for 25–150 and 600–900 °C; 2.5 °C/min for 150–600 °C) were found to give optimal results. Hg step-release experiments indicated that significant Hg isotopic fractionation occurred during sample combustion. However, no systematic dependence of Hg isotopic compositions on Hg recovery (81–102 %) was observed. The tested 340 samples including coal, coal-associated rocks, fly ash, bottom ash, peat, and black shale sediments with Hg concentrations varying from <5 ng/g to 10 μg/g showed that most Hg recoveries were within the acceptable range of 80–120 %. This protocol has the advantages of a short sample processing time (∼3.5 h) and limited transfer of residual sample matrix into the Hg trapping solution. This in turn limits matrix interferences on the Hg reduction efficiency of the cold vapor generator used for Hg isotopic analysis.

A Catalyst Tube-Equipped Dual-Stage Tube Furnace System for Accurate Hg Isotopic Determination of Ore Samples Using Neptune Plus Multicollector Inductively Coupled Plasma Mass Spectrometry

High Precision Isotope Ratio Measurements of Mercury Isotopes in Cinnabar Ores Using Multi-Collector Inductively Coupled Plasma Mass Spectrometry

A Double-Stage Tube Furnace--acid-trapping Protocol for the Pre-Concentration of Mercury from Solid Samples for Isotopic Analysis.

Interfacing Nanoliter Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry with an In-Column High-Pressure Nebulizer for Mercury Speciation.

Development and initial evaluation of a combustion-based sample introduction system for direct isotopic analysis of mercury in solid samples via multi-collector ICP-mass spectrometry

High Precision Hg Isotope Analysis of Environmental Samples Using Gold Trap-Mc-Icp-Ms

High Precision Determination of Mercury Isotope Ratios Using Online Mercury Vapor Generation System Coupled with Multicollector Inductively Coupled Plasma-Mass Spectrometer

Simultaneous Multi-Elemental Speciation of As, Hg and Pb by Inductively Coupled Plasma Mass Spectrometry Interfaced with High-Performance Liquid Chromatography

Determination of Mercurial Species in Fish by Inductively Coupled Plasma Mass Spectrometry with Anion Exchange Chromatographic Separation

Continuous Flow-Double Purge and Trap Method for Preconcentrating Mercury in Large Volumes of Seawater for Stable Isotope Analysis

A new HG/LT-GC/ICP-MS multi-element speciation technique for real samples in different matrices

High-precision Determination of Stable Potassium and Magnesium Isotopes Utilizing Single Column Separation and Multicollector Inductively Coupled Plasma Mass Spectrometry

Extending the application range of Hg isotopic analysis to sub-μg L−1 levels using cold vapor generation multi-collector inductively coupled plasma-mass spectrometry with 1013 ohm Faraday cup amplifiers

Online solid sampling platform using multi-wall carbon nanotube assisted matrix solid phase dispersion for mercury speciation in fish by HPLC-ICP-MS

In Situ Experimental Measurement of Mercury by Combining PGNAA and Characteristic X-ray Fluorescence.

Determination of Trace Mercury Isotopes in Liquid and Solid Samples by Inductively Coupled Plasma Mass Spectrometry with Oxidation , Purge-Trap , Dual-Stage Thermal Desorption.

A single-column and efficient procedure for separating Fe and Mg from geological materials for isotopic analyses using MC-ICP-MS

Crustal Mercury Addition into the Giant Jinchuan Ni‐Cu Sulfide Deposit, China, and Its Geological Implications

Determination of the Isotopic Composition of Aqueous Mercury in a Paddy Ecosystem Using Diffusive Gradients in Thin Films.

An improved dual-stage protocol to pre-concentrate mercury from airborne particles for precise isotopic measurement

A novel application of an isotope binary mixing model for determination of precise mercury isotopic composition in samples with low mercury concentration.