Experimental Study on Burning Behavior of N-Heptane in Ice Cavities with Different Aspect Ratios
Jie Ji,Sai Luo,Zhiyong Wang
DOI: https://doi.org/10.1016/j.fuel.2022.125627
IF: 7.4
2022-01-01
Fuel
Abstract:In situ burning is a widely used method in oil spill cleanup. This paper aims to study the burning behavior of n-heptane in ice cavities with aspect ratios ranging from 1 to 10. The depth and opening area of ice cavities were 9 cm and about 100 cm2, respectively, for all cases before ignition. Results show that the dynamic variation process of burning zone is different in square cavities and cavities with aspect ratio larger than one. For square cavities, the flame accumulates in the middle area of the cavity after ignition. For cavities with aspect ratio larger than one, at the early stage, there are unevenly distributed clusters of pulsating flames; and afterwards, the flames at different positions are gradually connected as a whole. A ring-shaped flame is observed in all cases before the extinguishing, and through theoretical analysis, it is believed that this phenomenon may be caused by the surface tension driven flow inside the water layer. In each case, at the same height, invasion lengths, i.e., horizontal distance between the cavity edge before and after burning, along the short and long sides are basically the same (average relative standard deviation: 1.60 %). And the invasion lengths show a non-monotonic trend of increasing first and then decreasing slightly with height in all cases. In addition, at the same height, the opening area of cavity increases as aspect ratio increases. For cavities with the same initial fuel layer thickness and fuel volume, the variation of aspect ratio results in little change in the growth and decay rate of mass loss rate, with the maximum relative standard deviation of 8.84 %. Heat is lost via thermal radiative penetration, conduction of fuel layer to ice walls, and conduction of fuel layer to water. Based on calculation, it is found the sharp decrease of mass loss rate cannot only be attributed to conductive heat loss, thermal radiative penetration is also an important part, which even accounts for about one-third of the total heat loss.