Abstract:Few studies/bodies of data are available in the open literature on the topic of mechanical material characterisation and structural performance for direct/inline compounded long fibre thermoplastic (LFT) automotive parts, particularly incorporating carbon fibre. Therefore, this study aimed to comprehensively document the mechanical properties of a seatback for a lightweight automotive seating design, compression moulded from carbon fibre/polyamide 66 on a Dieffenbacher LFT-D manufacturing line. The methodology consisted of extracting and characterising mechanical behaviour of tensile specimens from full seatback components and completing quasi-static and low velocity impact loading on these seatbacks. Both longitudinal and transverse charge placements within the compression mould were considered. Main findings from the tensile tests noted a dependency of the mechanical properties based upon the location from which specimens were extracted; from the charge region, the elastic moduli in the 0° and 90° directions were similar (0°: 14.0GPa & 90° 15.9GPa with coefficients of variation (CoV) of 56% and 36%, respectively) or, for the case of specimens extracted from the flow region, exhibited significant anisotropy (elastic moduli in the 0° direction 9.79GPa and 90° direction 21.6GPa, with CoV's of 16% and 23%). In terms of anisotropy of the full seatback component, under low velocity impact loading a local force maxima was observed for seatbacks produced with a longitudinal charge orientation at deflections of approximately 15 to 20mm. No local maxima were consistently observed for transverse charge seatbacks. In terms of rate effects, stiffness was 550% higher for low velocity impact with respect to quasi-static loading. Digital image correlation identified a greater level of deformation, particularly away from the indenter, for quasi-static loading. Catastrophic failure occurred at larger deflections for low velocity impact (36% increase for longitudinal charge placement, 24% for transverse). The results of this investigation have practical applications for engineers in industry considering direct/inline compounded carbon fibre LFT materials in cases where quasi-static and dynamic loading will be present, for example, automotive chassis/body structural components.

Ply Optimization of Backrest Skeleton of Carbon Fiber Reinforced Plastic Car Seat Based on Grey Euclidean Relational Analysis Method

Multi-objective optimization design of automobile seat backrest considering coupling effect

Optimisation design of CFRP passenger car seat backplane based on impact characteristics

Failure analysis and optimization design of CFRP automotive seat back under multiple conditions

Lightweight Design of Differential Thickness-Carbon Fiber Reinforced Plastic Car Seat Backrest

Lightweight optimization of passenger car seat frame based on grey relational analysis and optimized coefficient of variation

A new optimization strategy for multi-objective design of automotive seat frame

Topological optimisation design of passenger car seat backrest frame based on multiple-loading conditions

Multi-objective optimization design of rear seat for a passenger car based on GARS and NSGA-III

Optimizing the design of automotive S-rail using grey relational analysis coupled with grey entropy measurement to improve crashworthiness

Application Research on the Lightweight Design and Optimization of Carbon Fiber Reinforced Polymers (CFRP) Floor for Automobile

Structure design of LFT passenger car seat structure based on topology optimisation

Reliability-based multilevel optimization of carbon fiber-reinforced plastic control arm

Experimental characterisation of the mechanical properties of a carbon fibre/PA66 LFT automotive seatback under quasi-static and impact loading

Optimal Design of a Fiber-Reinforced Plastic Composite Sandwich Structure for the Base Plate of Aircraft Pallets In Order to Reduce Weight

Performance comparison between glass and basalt fibre-reinforced composites for an automotive seat backrest

Research on the Optimization of Automobile Plastic Front Frame Structure

Structure–connection–performance integration lightweight optimisation design of multi-material automotive body skeleton

Ply optimization of carbon fiber-reinforced plastics laminates based on a gradient-based optimization method with manufacturing constraints

Lightweight Design of Car Seat Structure

A performance-driven lightweight optimization method for material-structure coupling design of cab