Introducing Relatively Isolated In/Out‐Gap Bands in Cs2XCl6 (X = Sn, Hf, Zr, Ti) via B‐Site Substitution: A Route to Brighter Luminescence and Tunable Emission Wavelengths

Zhenren Gao,Xing Shen,Pengbo Lyu,Changfu Xu,Dong Fan,Lizhong Sun

DOI: https://doi.org/10.1002/adom.202300956

IF: 9

2023-09-12

Advanced Optical Materials

Abstract:By substituting Sn with Te, impurity bands can be introduced into the host material, thereby overcoming the restrictions imposed by parity and resulting in yellow‐green fluorescence. The emission of a single peak of ≈580 nm is a result of the radiative transition between out‐gap bands (OGBs) and in‐gap bands (IGBs), with the broadening of the emission peak attributed to self‐trapped excitons (STEs). Further research suggests that precise control over the position of IGBs and OGBs through cation selection enables the fine‐tuning of emission wavelengths. Both theoretical and experimental approaches are utilized to investigate the fluorescence mechanism of B‐site substituted Cs2XCl6 (A2BX6‐type perovskite, X = Sn, Hf, Zr, Ti), aiming to enhance the luminescence and tune the emission wavelengths. Using Te‐monosubstituted Cs2SnCl6 as a model system, thecomputational discovery that the introduction of out‐gap and in‐gap bands by Te can significantly enhance its transition dipole moment is reported. This is further experimentally confirmed, showing a single emission peak resulting from the radiative transition between the out‐gap and in‐gap bands. The broadening of the emission peak is attributed to self‐trapped exciton (STE), while additional absorption/excitation peaks arise from composition segregation. Additionally, the high‐throughput first‐principles calculations indicate that substituting B‐sites of Cs2XCl6 with Se, Te, Po, As, Sb, and Bi may also significantly enhance their light emission with the introduced bands. Thus, fine‐tuning the emission wavelengths by controlling the position of out‐gap and in‐gap bands through cation selection is proposed. Furthermore, tunable white‐light emission is achieved with excellent color stability by adjusting the Te and Bi composition in co‐substituted Cs2SnCl6 material. The findings highlight the potential of utilizing out‐gap and in‐gap bands to tune luminescence in this perovskite family for advanced device applications, including white‐light‐emitting diodes (WLEDs).

materials science, multidisciplinary,optics