Abstract:The microfluid jet polishing (MFJP) process is a manufacturing technology in which small abrasive particles (such as diamond, alumina, and ceria) are premixed with a carrier fluid (typically water) to form a liquid suspension that is pressurized and expelled through a nozzle for material removal. The resulting microjet beam—with a typical nozzle exit diameter in the range from 0.1 to 1.0 mm—impinges the workpiece surface for material removal by erosion and/or abrasion and produces an ultraprecision surface. This work applies a computational fluid dynamics (CFD) model to analyze the key phenomena in the interaction of the liquid suspension and the workpiece surface. The liquid film characteristics (film height, minimum film height, positions of the minimum film height, and hydraulic jump) obtained from the CFD simulations are compared with the results derived from empirical formulations found in the literature. Subsequently, the numerical results are utilized to investigate the impact velocity, pressure distribution, and shear stress caused by the suspension on the workpiece surface. It is observed that the shear stress strongly depends on the injection pressure of the liquid suspension and is weakly dependent on the abrasive suspension concentration (the liquid suspension with different densities, viscosities, and surface tensions). Additionally, the particle behavior is investigated in order to estimate the impact velocity and to identify the impact and erosion zones of the liquid suspension on the workpiece surface. Numerical results indicate that ~50% of total particles are impinging the workpiece surface almost perpendicularly (with a mean impact angle of ~86 degrees) for the first time in the stagnation region, where they are strongly decelerated by the carrier fluid before they reach the workpiece surface. These particles, however, rebound on the surface and are reaccelerated by the carrier fluid, impinging the workpiece surface further in the radial direction.

Surface morphology in plasma jet polishing: theoretical description and application

Plasma jet assisted polishing of fused silica freeform optics

Preliminary Study of Disc Hydrodynamic Polishing

Modelling of surface morphology and roughness in fluid jet polishing

Theoretical and experimental investigation of three-dimensional-structured surface generation using fluid jet polishing

Study of Form Control Algorithm in Atmospheric Pressure Plasma Processing

Maskless fluid jet polishing of optical structured surfaces

Surface generation modelling and form maintenance strategy in maskless fluid jet polishing of structured array surface

Towards an Understanding of Multiphase Fluid Dynamics of a Microfluid Jet Polishing Process: A Numerical Analysis

Surface roughness and material removal in fluid jet polishing

A novel approach of jet polishing for interior surface of small grooved components using three developed setups

Numerical Simulation of the Nanoparticle-Surface Collision in a Liquid Jet and Its Effects on Material Removal

Modeling and analysis for material removal and surface roughness in fluid jet polishing of optical glass

High-Accuracy Surface Topography Manufacturing for Continuous Phase Plates Using an Atmospheric Pressure Plasma Jet

Numerical and experimental investigation on the material removal profile during polishing of inner surfaces using an abrasive rotating jet

Analysis Of Composite Flow Field Characteristics In Fluid Jet Polishing

Novel multiphase jet polishing for complicated structured components produced by laser powder bed fusion

Optimization of the Morphology of the Removal Function for Rotating Abrasive Water Jet Polishing

Design and development of medium-pressure plasma process for optical substrate finishing: A comparative study with wet chemical etching

Interaction of atmospheric pressure plasma jet with a dielectric surface: relative permittivity and roughness

The Influence of Impact Angle on Material Removal in Fluid Jet Polishing