Abstract:Unmanned aerial vehicle (UAV) navigation has recently been the focus of many studies. The most challenging aspect of UAV navigation is maintaining accurate and reliable pose estimation. In outdoor environments, global navigation satellite systems (GNSS) are typically used for UAV localization. However, relying solely on GNSS might pose safety risks in the event of receiver malfunction or antenna installation error. In this research, an unmanned aerial system (UAS) employing the Applanix APX15 GNSS/IMU board, a Velodyne Puck LiDAR sensor, and a Sony a7R II high-resolution camera was used to collect data for the purpose of developing a multi-sensor integration system. Unfortunately, due to a malfunctioning GNSS antenna, there were numerous prolonged GNSS signal outages. As a result, the GNSS/INS processing failed after obtaining an error that exceeded 25 km. To resolve this issue and to recover the precise trajectory of the UAV, a GNSS/INS/LiDAR integrated navigation system was developed. The LiDAR data were first processed using the optimized LOAM SLAM algorithm, which yielded the position and orientation estimates. Pix4D Mapper software was then used to process the camera images in the presence of ground control points (GCPs), which resulted in the precise camera positions and orientations that served as ground truth. All sensor data were timestamped by GPS, and all datasets were sampled at 10 Hz to match those of the LiDAR scans. Two case studies were considered, namely complete GNSS outage and assistance from GNSS PPP solution. In comparison to the complete GNSS outage, the results for the second case study were significantly improved. The improvement is described in terms of RMSE reductions of approximately 51% and 78% for the horizontal and vertical directions, respectively. Additionally, the RMSE of the roll and yaw angles was reduced by 13% and 30%, respectively. However, the RMSE of the pitch angle was increased by about 13%.

GNSS/MEMS-INS Integration for Drone Navigation Using EKF on Lie Groups

Tight Fusion of a Monocular Camera, MEMS-IMU, and Single-Frequency Multi-GNSS RTK for Precise Navigation in GNSS-Challenged Environments

Revisiting multi-GNSS Navigation for UAVs -- An Equivariant Filtering Approach

Enhanced Autonomous Vehicle Positioning Using a Loosely Coupled INS/GNSS-Based Invariant-EKF Integration

INS/GNSS Integration for Aerobatic Flight Applications and Aircraft Motion Surveying

Navigation for fixed-wing unmanned aerial vehicles in the presence of GNSS outages

An Improved Initial Alignment Method Based on SE2(3)/EKF for SINS/GNSS Integrated Navigation System with Large Misalignment Angles

Semi-Aerodynamic Model Aided Invariant Kalman Filtering for UAV Full-State Estimation

Clifford Algebra-Based Iterated Extended Kalman Filter with Application to Low-Cost INS/GNSS Navigation

Integrating Extreme Learning Machine with Kalman Filter to Bridge GPS Outages

A Lie Group Manifold-Based Nonlinear Estimation Algorithm and Its Application to Low-Accuracy SINS/GNSS Integrated Navigation

Deep Learning-Aided Inertial/Visual/LiDAR Integration for GNSS-Challenging Environments

Kalman Filtering Algorithm for Integrated Navigation System in Unmanned Aerial Vehicle

Lie group based nonlinear error models for SINS/DVL integrated navigation

Sensor Fusion for Underwater Vehicle Navigation Compensating Misalignment Using Lie Theory

An Invariant Filtering Method Based on Frame Transformed for Underwater INS/DVL/PS Navigation

Continuous and Precise Positioning in Urban Environments by Tightly Coupled Integration of GNSS, INS and Vision

High accuracy Navigation System using GPS and INS system integration strategy

A GNSS/INS/LiDAR Integration Scheme for UAV-Based Navigation in GNSS-Challenging Environments

Geometric stochastic filter with guaranteed performance for autonomous navigation based on IMU and feature sensor fusion

Enhanced Navigation Precision Through Interaction Multiple Filtering: Integrating Invariant and Extended Kalman Filters