Abstract:To overcome the problem of poor uniformity of solid-fertilizer-dissolving devices due to lag of fertilizer dissolution, a closed-loop control system based on fuzzy proportional-integral-derivative (PID) was designed and tested. A fertilizer concentration regulation model was then established according to the results. In this system, the control core was an STM32 used to feed back the fertilization concentration by detecting the electrical conductivity. For real-time adjustment of the fertilizer flow rate and water flow rate, a fuzzy PID control algorithm was utilized to compare the detected concentrations with the set concentrations. The linear relationships between quantities such as the fertilizer rate and PWM frequency, water flow rate and PWM duty ratio of the direct-current pump, and fertilizer concentration and electrical conductivity were all established to calibrate the system. The influence of the fertilizer flow rate and water flow rate on fertilizer concentration was determined by the control variable test method. The results showed a positive linear relationship between fertilizer concentration and fertilizer flow rate, while a reverse linear relationship was established between fertilizer concentration and water flow rate. After the introduction of the control system into the self-developed solid-fertilizer-dissolving device, the fertilizer concentration fluctuated near the set concentration in a range of no more than 1 g/L. After the disturbance of the fertilization device, the control system fine-tuned the device with a steady-state error of about 0.55 g/L after the system reached stability. The control system designed in this study was shown to run normally with good stability, speed, and accuracy, and with improved fertilization uniformity of the solid-fertilizer-dissolving device. This study lays the foundation for further study of fertilization control systems. It also provides a reference for the development of precise and intelligent fertigation.

Calcium carbide furnace batching system based on integral separation PID control

PIDNN Based Intelligent Control of Ignition Oven

Combining predictive functional control and PID for liquid level of coking furnace

Proportioning analysis and PLC control system design of calcium carbide furnace

PID control realization of drying system of the finishing line based on MCGS and PLC

Design and optimization of digitalization device of temperature control system using PID Ziegler-Nichols control in chemical engineering laboratory

Temperature Advanced Control System for Batch Chemical Reaction

A Simplified Linear Iterative Predictive Functional Control Approach for Chamber Pressure of Industrial Coke Furnace

An Expert PID Control Method for Level Control of CFB Boiler

A practical predictive control algorithm for embedded system and its application

Multi-variable PID Neural Network Decoupling Algorithm in Scrap Copper Smelting Process Control

Synthesis of a three-channel PID controller for controlling a three-zone medium-temperature furnace

Study of PID Control Algorithm Based on the Critical Ratio Method

Study and Realization of Automatic Control for Variable Flow Heating Systems

The Fuzzy Model PID Optimization Control Designed for a Heat Exchange System in a Packed Tower

Fuzzy-PID Control on Garbage Incineration Temperature

Design of the PID Controller for Circulating Fluidized Bed Boiler Combustion System

Design of vacuum annealing furnace temperature control system based on GA-Fuzzy-PID algorithm

Design and Experimental Testing of a Control System for a Solid-Fertilizer-Dissolving Device Based on Fuzzy PID

Neural dynamic programming based temperature optimal control for cement calcined process

Feed Furnace Temperature Control Based on the Distributed Deviations