Abstract:A novel design for a low dropout (LDO) voltage regulator is presented and dedicated to power many sections of a typical cellular handset. However, these baseband, RF, and audio sections have different requirements that influence which LDO is most appropriate. After discussion of the specific requirements, different LDOs are recommended. Also, some LDO design techniques are briefly discussed to demonstrate how an LDO may be optimized for a specific level of performance. Cellular phone designs require linear regulators with lowdropout, low-noise, high PSRR, low quiescent current (Iq), and low-cost. They need to deliver a stable output and use smallvalue output capacitors. Ideally, one device would have all these characteristics and one low-dropout linear regulator (LDO) could be used anywhere in the phone without worry. But in practice, the various cell phone blocks are best powered by LDOs with different performance characteristics. This paper provides a new design methodology to choosing the right LDO to power each cell phone and especially for the Voltage Phase-Locked loops (VPLLs) blocks. Fabricated in a 0.18 {\mu}m CMOS process, the measured results show the adopted topology achieves a better phase noise than the conventional saturation current source. and the spread of the current limitation (without matching) is 100mA, the VPLLs system demonstrates a phase noise of 782 nv/sqrtHz at 100-kHz, and 33 nv/sqrtHz at 1 MHz, while quiescent current 33 {\mu}A from a 2.6 V supply voltage.

The Design of An LDO Regulator

A Novel Fully On-Chip CMOS Low-Dropout Linear Regulator with Ultra Low Noise

A 300 mA 0.18 μm CMOS low-dropout regulator with high power-supply rejection

Analysis and Design of High Power Supply Rejection LDO

A Low-dropout Regulator with Low Quiescent Current and High Stability

A Low-dropout Regulator with Unconditional Stability and Low Quiescent Current

Analysis and Optimization of a Low-Noise LDO

Low-dropout regulator with no off-chip capacitor and ultra low power consumption

The Design of An LDO Regulator [The Analog Mind]

CMOS Low-Dropout Voltage Regulator Design Trends: An Overview

Noise Aware Fully Integrated Low Power and Low Inrush Current Fast Transient Response LDO

Highly Stable Low-Dropout Linear Regulator with Temperature Compensation

Design of LDO voltage regulator with low noise and high PSRR

Design Trends and Perspectives of Digital Low Dropout Voltage Regulators for Low Voltage Mobile Applications: A Review

Design and simulation of low dropout voltage regulator using 180nm technology

A 100 mA Low Voltage Linear Regulators for Systems on Chip Applications Using 0.18 μm CMOS Technology

14.7 A Modular Hybrid LDO with Fast Load-Transient Response and Programmable PSRR in 14nm CMOS Featuring Dynamic Clamp Tuning and Time-Constant Compensation

A Low Noise, Fast Set-Up Low-Dropout Regulator in 65nm Technology

A High-Performance LDO Regulator Enabling Low-Power SoC With Voltage Scaling Approaches

A Hybrid-Mode LDO Regulator with Fast Transient Response Performance for IoT applications

Ldo Chip Advanced Technology Development Exploration