P‐Type Doping of PM6:Y6‐Based Photoactive Layer with Formic Acid

Nara Han,Minwoo Lee,Yina Moon,Dongseong Yang,Jeongwoo Beak,Chang-Mok Oh,In-Wook Hwang,Dong-Yu Kim
DOI: https://doi.org/10.1002/solr.202300312
IF: 9.1726
2023-06-15
Solar RRL
Abstract:The introduction of molecular doping process is necessary to enhance the optic and electronic properties of organic semiconductors for facilitating charge transport. In particular, since the doping process has a positive influence on the charge transfer interaction between host semiconductor and dopant, improved mobility has been efficiently achieved. Despite its advantages, doping technologies in organic solar cells (OSCs) are emphasized to the development of n‐type dopants used for balancing the electron and hole. In addition, since the bulk‐heterojunction microstructure in OSCs has randomly blended phases of the donor and acceptor, it is important to optimize charge extraction without loss by controlling the morphology. In this study, we report OSCs by p‐type doping with formic acid (FA) into a photoactive layer. The champion device yields a significantly improved power conversion efficiency from 14.3% to 15.3% with a high fill factor of 71.7%. It is found that the p‐doped photoactive layer exhibits enhanced conductivity, improved carrier mobilities, suppressed charge recombination, and lowered leakage current. The FA simultaneously acts as a film morphology controller of the photoactive layer with enhanced phase separation to transport the charge efficiently. Thus, the doping process with FA can maintain the device performance in stability tests (95.6% remaining). This article is protected by copyright. All rights reserved.
energy & fuels,materials science, multidisciplinary
What problem does this paper attempt to address?