Sodium-Ion Concentration Extraction in Dermis Layer by Time-Constant-Domain Electrical Impedance Spectroscopy (TCD-EIS) With Dermis Separation Model (DSM)

Kiagus Aufa Ibrahim,Marlin Ramadhan Baidillah,Ridwan Wicaksono,Shinsuke Akita,Masahiro Takei
DOI: https://doi.org/10.1109/tim.2024.3366287
IF: 5.6
2024-03-09
IEEE Transactions on Instrumentation and Measurement
Abstract:Sodium-ion concentration in the dermis layer has been extracted by time-constant-domain electrical impedance spectroscopy (TCD-EIS) with the dermis separation model (DSM). The TCD-EIS with DSM consists of the dermis separation formulation, ridge regression optimization, and distribution of relaxation times (DRTs) with radial basis function. To distinguish the relaxation time of the dermis from the other layers (stratum corneum , the epidermis , and the fat layer ), the subtracted impedivity was calculated by distant electrode pair , and close the electrode pair , based on optimum electrode diameter and distance . The numerical optimizations were implemented to optimize from 0.5 to 3 mm and from 2 to 8 mm, regarded as DSM sensor parameters. In the simulation, the optimized DSM sensor parameters, = 1 mm and = 1 mm, were applied to the skin model under the condition of: 1) various sodium-ion concentrations in the dermis layer and 2) frequencies from 100 Hz to 1 MHz. In the experiments, the optimized TCD-EIS with DSM was applied to porcine skin under the condition following the simulations. The relation between the distribution function and relaxation times was used to evaluate the sodium-ion concentration extraction. Both simulation and experiment results show that the normalized distribution function of the dermis decreases with the increase of sodium-ion concentration . The sodium-ion concentration in the dermis layer was distinguished properly at dermis relaxation times s. TCD-EIS with DSM reveals that the decrease of a normalized distribution function correlates with the increased sodium-ion concentration injected in the dermis layer.
engineering, electrical & electronic,instruments & instrumentation
What problem does this paper attempt to address?