Abstract:Considering the need for biodiesel production from non-edible oil sources and taking into account the fact that Prosopis Juliflora (JF) is identified as a highly invasive species in Ethiopia, this research focuses on biodiesel production from a possible and promising alternative feedstock. The objective of this study is to analyze Ethiopian variant Juliflora based biodiesel (JFB) production through transesterification, carry out optimization by exploring the effects of various process parameters and characterization of functional groups (with GC-MS,FT-IR and NMR) including rheological behavior, not yet been reported earlier. As per ASTM protocol testing, the methyl ester of Juliflora has been found to have the following main fuel properties: kinematic viscosity (mm2/s) 3.395, cetane number 52.9, acid number (mgkoh/g) 0.28, density (gm/ml) 0.880, calorific value (MJ/kg) 44.4, methyl ester content (%) 99.8, and flashpoint (°C) 128, copper strip corrosion value 1a,%FFA (free fatty acid) 0.14. When compared with those of diesel, the viscosity, density, and flash point of JFB are seen to be higher than those of diesel, although it has a similar calorific value but more importantly higher than most of the other biodiesels. Based on an assessment using response surface methodology, methanol concentration together with catalyst loading, temperature, and reaction time are determined to be the most important influencing process parameters. The best molar ratio for methanolysis was observed to be 6:1 with a catalyst concentration of 0.5 wt% at 55 °C for 60 min for biodiesel yield at 65%. The JFB maximum yield of 130 ml at 70 min and the minimum yield of 40 ml at 10 min demonstrate that as mixing time increases, JFB yield tend to increase up to a certain time limit. The maximum raw oil yield rom crushed seed with hexane solvent was observed to be 480 ml within 3 days from 2.5 kg of crushed seed. The Fourier transform infrared analysis (FT-IR) revealed the presence of all desired functional groups necessary for biodiesel on OH radicals at wave numbers of 3314.40 cm-1, Aliphatic methyl C-H at 2942.48 cm- 1 with a functional group (CH-3-,-CH2-), and methylene C-H at 2832.59 cm-1. The gas chromatography-mass spectrometer (GC-MS) study confirmed the higher ester content present in the JFB with a higher unsaturation level of 68.81%. The fatty acid, oleic acid has a lower saturation level of 4.5%, while palmitic acid has a lower threshold level of 2.08%. The Rheometer test showed that shear stress and viscosity reduced with increasing temperature within the range of biodiesel requirements, and the Newtonian behavior was confirmed. The JFB has a fairly high viscosity and shear rate at low temperatures. The 1H NMR (nuclear magnetic resonance) study established that JFB has a necessary ingredient; and aliphatic resonances occur in the chemical shift region of 1.5-3.0 ppm. Significant regions indicate protons bound to heteroaromatics, aldehydes, as shown by 13C NMR spectrum. The findings from the FT-IR, GC-MS, 1H NMR, and 13C NMR are in agreement thus validating the presence of numerous functional groups in JFB as such. Since JFB possesses the requisite biodiesel fuel attributes, Prosopis Juliflora need to be pursued as a promising biodiesel feedstock in Ethiopia for alleviating the burden of imported fuels while also addressing difficulties with emissions released by the combustion of fossil fuels.

GC/MS quantification of individual fatty acids of selected green leafy vegetable foliage and their biodiesel attributes

Biodiesel production and selected fuel qualities from prospective non-edible oils: Hevea brasiliensis, Madhuca longifolia, Azadirachta indica, and Gossypium hirsutum

Response surface methodology as a statistical tool for optimization and FAME profile by GC-MS for assessing microalgae Scenedesmus quadricauda as a potential biodiesel feedstock

Salvia farinacea seed oil, a potential biomass for synthesis of biodiesel: A critical analysis of its fuel properties.

Influence of fatty acids content in non-edible oil for biodiesel properties

Development of Free Fatty Acid (FFA) monitoring device for evaluation of oil samples used for biodiesel production

Exploration of the Lipid Profile of Edible Oleaginous Microgreens by Mass Spectrometry-Based Lipidomics

Multielemental Analysis of Biodiesel by Dynamic Reaction Cell–Inductively Coupled Plasma-Mass Spectrometry

Efficient separation and quantification of methyl palmitate and methyl oleate in biodiesel mixture using reverse-phase high performance liquid chromatography

Extraction and Quality Evaluation of Biodiesel from Six Familiar Non-Edible Plants Seeds

Identification of novel, non‐edible oil seeds via scanning electron microscopy as potential feedstock for green synthesis of biodiesel

A data processing method for the determination of the concentration of the components of unsaponifiable matter in vegetable oils

Deeper investigation of oxygen-containing compounds in oleaginous feedstock (animal fat) by preparative column chromatography and comprehensive two-dimensional gas chromatography coupled with high-resolution time-of-flight mass spectrometry

Fourier transform infrared spectroscopy (FTIR) analysis, chlorophyll content and antioxidant properties of native and defatted foliage of green leafy vegetables

Extraction and Identification of Glycerides in Sesamum indicum Oil Seeds from Manipur

Optimisation, experimental validation and thermodynamic study of the sequential oil extraction and biodiesel production processes from seeds of Sterculia foetida

In-depth multi-component analysis of bio-aviation fuel derived from waste cooking oil using comprehensive two-dimensional gas chromatography mass spectrometry

Production, optimization, and characterization of Ethiopian variant Prosopis juliflora based biodiesel

GC-MS-Based Analysis of Methanol: Chloroform-extracted Fatty Acids from Plant Tissues

Unraveling the bioenergy production potential of native Scenedesmus and Nannochloropsis species by ameliorating non-polar lipids and desirable fatty acid production

Scanning electron microscopic identification of ten novel, non‐edible oil seeds for bioenergy production