Abstract:New developments in instrumentation for ocean environmental engineering are allowing unprecedented levels of trace contaminant measurement in the deep ocean. With funding from the U.S. National Science Foundation (NSF), our engineering design team constructed a new mass spectrometer-based in situ analysis system for work in the deep ocean environment over prolonged deployment periods. Our design goals were a depth capability of up to 4,000 m water depth (400 bars hydrostatic pressure) and autonomous operation for periods of up to six months to a year, depending upon the type of external battery system used or other deployment circumstances, e.g., availability of a power cable or fuel cell power source. We chose a membrane introduction mass spectrometry (MIMS) sampling approach, which allows for dissolved gases and volatile organics introduction into the mass spectrometer vacuum system. The MIMS approach and the hydrophobic, silicon-coated membrane chosen both draw upon our previous experience with this technology in the deep ocean. The membrane has been tested to 400 bars in a series of long-term hydrostatic pressure tests, which extend the 200-bar working depth rating of this membrane by a factor of 2. Long-term deployment capability of the moderately powered, approximately 100 W system, was accomplished by power management of the embedded computer system and custom electronics with Windows-based and custom software now fully-developed and bench tested. The entire system fits within a 6.5-inch outside diameter pressure housing that is approximately five feet long. It consists of a 1 to 200 amu range quadrupole mass spectrometer equipped with Faraday and electron multiplier detectors, compact turbo-molecular and backing diaphragm vacuum pumps, internal rechargeable batteries, and internal waste vacuum chamber. Sample routing past the MIMS is accomplished by computer-controlled solenoid valves. We designed the pressure housings of both 6AL4V and type 2 titanium alloys that are rated to working depths of >4,000 m and are essentially corrosion proof over long-term deployments. We designed and integrated a fail-safe valving system for both rapid response to high-pressure MIMS failure and a pressure-switch circuit and high-pressure solenoid valve to detect and protect against slow leaks of the MIMS. To route sample waters to the MIMS-based instrument, we also designed and built a rugged plastic plenum that couples to the face of the sampler head, the latter of which consists of the MIMS inlet and a full-ocean rated thermister temperature probe with an operational range from −5 to 50°C. These instrumentation innovations will be described in the paper.

Preliminary results from the Submarine Gamma Imager

A new natural gamma radiation measurement system for marine sediment and rock analysis

Characterization of a CZT-based spectrometer for underwater operation via simulations and experiments

The XGIS instrument on-board THESEUS: detector principle and read-out electronics

Integrated regional scale view of Milos submarine hydrothermalism

The XGIS instrument on-board THESEUS: the detection plane and on-board electronics

Novel applications of state-of-the-art gamma-ray imaging technique: from nuclear decommissioning and radioprotection to radiological characterization and safeguards

SST-1M : Commissioning and Preliminary Observation Results

Design of a Prototype in-situ Gamma-ray Spectrometer for Deep Sea

Deep seawater inherent optical properties in the Southern Ionian Sea

Detection and Imaging of High-Z Materials with a Muon Tomography Station Using GEM Detectors

First results of undersea muography with the Tokyo-Bay Seafloor Hyper-Kilometric Submarine Deep Detector

Using Cosmic Ray Muons to Assess Geological Characteristics in the Subsurface

Combined optical and single photon emission imaging: preliminary results

Design of the SABAT system for underwater detection of dangerous substances

Configuration studies for a cubic-kilometre deep-sea neutrino telescope - KM3NeT - with NESSY, a fast and flexible approach

Geoscience Visual Presentation G10: Development of a novel seismic acquisition system based on fully autonomous ocean bottom nodes

Nuclear fuel imaging using position-sensitive detectors

Benchmarking COSI's detector effects engine

Development of an autonomous station for measurements of artificial gamma activity in surface water bodies

A Deep-Ocean Mass Spectrometer to Monitor Hydrocarbon Seeps and Pipelines