Abstract:In order to cure the transverse and longitudinal coupled bunch instabilities caused by higher order modes of RF cavities and resistive wall impedance in the BEPCII storage rings, two type bunch by bunch feedback systems of longitudinal feedback system and transverse feedback system are used. The electronics of LFB system are digital system produced by Dimtel Company, the longitudinal kicker is drift-tube type borrowed from the SLAC. An analog bunch-by-bunch transverse feedback system was designed and used. The main components are two sets of beam oscillation detectors, betatron phase adjuster, notch filter, and stripline kicker. This paper will describe the achieved results of curing the coupled bunch instabilities by using the LFB and TFB together with current status. INTRODUCTION BEPCII is an upgrade project of the Beijing Positron Electron Collider (BEPC), in which a new inner ring has been installed inside the old one. BEPCII will provide colliding beams with 910mA at the centre-of-mass energy 1.89GeV in colliding mode. When the current reaches to 200mA, strong transverse instabilities occurred in both BEPCII electron and positron rings which limited the maximum storable currents. In order to cure these instabilities, two sets of analog transverse bunch-by-bunch feedback systems (TFB) for both rings have been developed and put into operation. The transverse feedback systems suppress the instabilities and make the beams stable to collide [1]. In colliding mode, there are more than 100 bunches in every rings, the bunch spacing is 4ns or 6ns. In the last run, over 750mA beams have been successfully stored in both rings. The colliding luminosity has been reached to 7.08×10 cms. In the operation of BEPCII, we found that the bunch luminosity decreases along the bunch trains even the transverse instabilities were cured. Many experiments have proved that this phenomenon was caused by longitudinal instability. So in the year of 2010, we set up and commissioned digital longitudinal feedback systems (LFB) for both rings. The LFB system is composed of front-end electronics and back-end electronics (FBE500L), signal processing electronics (iGp) and power amplifier and kicker. The electronics are bought from DIMTEL Company, USA. The longitudinal kicker is drift-tube type which borrowed from the SLAC. The longitudinal feedback system performed well and has increased luminosity up by 30%. In this paper, we will describe the components of feedback systems and the performing results of them. TRANSVERSE FEEDBACK SYSTEM BEPCII TFB system is same as the systems developed in ALS [2], PLS [3]. It consists of pickup electrodes, signal processing electronics, power amplifiers, and a stripline kicker. Figure 1 shows an overview of the transverse feedback system. Two x (or y) signals from pickups located about 90 degrees apart in betatron phase are added together with appropriate coefficients to produce a 90-degree betatron phase shift between the pickup signal and the kicker. The beam oscillation signal is detected at 1.5GHz in order to take advantage of the good sensitivity of the button pickups at this frequency. The signals then are demodulated to the baseband with heterodyne receivers. The DC offset at the pickups is removed by using a two-tap notch filter. The one-turn delay is provided by coaxial cable. In each ring there is one stripline kicker and four 75-watt power amplifiers for both directions to apply the correction kick signal to the beam.

Fast Electronics for the Dafne Transverse Feedback Systems

Digital Bunch-By-Bunch Transverse Feedback System at Ssrf

Mitigation and control of instabilities in DAFNE positron ring

Intra-bunch feedback system developments at DAFNE

Longitudinal and transverse feedback systems for the bepcii storage rings

Research of bunch by bunch data acquisition system in SSRF

The Application of FPGA-based DSP Module in SSRF Storage Ring

Bunch-by-bunch Beam Transverse Feedback Electronics Designed for SSRF

Electron beam diagnostics based on transverse feedback system at duke storage ring

Multi-bunch Feedback Systems

Digital transverse bunch-by-bunch feedback system of Hefei light source

Design and Testing of a Bunch-by-bunch Beam Position Transverse Feedback Processor

A high-resolution, low-latency, bunch-by-bunch feedback system for nano-beam stabilization

Design of Bunch-by-bunch Measuring and Transverse Feedback System at HLS

Development of Digital Transverse Bunch-by-bunch Feedback System of HLS

A Betatron Tune Measurement System Based on Bunch-by-bunch Transverse Feedback at the Duke Storage Ring

Dafne Lifetime Optimization with Compensating Wires and Octupoles

Using the transverse digital damper as a real-time tune monitor for the Booster synchrotron at Fermilab

Preliminary Measurements for a Sub-Femtosecond Electron Bunch Length Diagnostic

A New Longitudinal Diagnostics System for CERN's Antiproton Machines

Beam-based Feedback for the Linac Coherent Light Source