Abstract:<p>Previous research has shown that nonemulative (jointed) precast walls with unbonded posttensioning can achieve superior seismic performance (e.g., self-centering) compared to conventional monolithic cast-in-place reinforced concrete walls. However, the progression of significant damage and failure in nonemulative precast walls is through the yielding of ductile steel reinforcing bars (referred to as energy dissipating bars) followed by the crushing of concrete at the wall toes, greatly limiting the ability to repair these walls after a major earthquake. In this paper, a nonemulative precast wall system with replaceable, external buckling restrained plates (BRPs) for energy dissipation, and steel jackets for confinement of the concrete at the wall base is investigated through reversed-cyclic lateral loading tests. Four precast wall specimens with varying cross-sectional area of the BRPs and number of horizontal joints were tested and compared against a monolithic cast-in-place reinforced concrete wall. The precast walls exhibited no significant unrepairable tensile or compressive damage with increasing lateral strength up to 4% drift, showing advantages over the cast-in-place wall and non-jacketed precast walls in previous research. With out-of-plane buckling restrained, the BRPs yielded in tension and compression, providing the precast walls with desirable energy dissipation. To highlight the reparability of the precast wall system, one of the specimens was repaired after being subjected to a complete cyclic loading history up to 4% drift. The repair was done by replacing the damaged BRPs, after which the wall was re-tested. The repaired wall restored most of its original energy dissipation, lateral stiffness, and strength, with limited cumulative damage in the wall. In general, the proposed precast wall system with buckling restrained plates is desirable for seismic regions, offering excellent reparability and seismic resilience.</p>

Seismic Performance of an Earthquake Resilient Self-Centering Precast Reinforced Concrete Rocking Wall with External SMA Rods

Self-centering Eccentrically Braced Frames Using Shape Memory Alloy Bolts and Post-Tensioned Tendons

Seismic performance of deficient RC frames retrofitted with SMA-reinforced ECC column jacketing

Seismic performance assessment of reinforced concrete coupled walls reinforced with different types of shape memory alloys

Seismic performance of a reinforced concrete building retrofitted with self-centering shape memory alloy braces

Resilient performance of self-centering hybrid rocking walls with curved interface under pseudo-static loading

Experimental-analytical investigation of accelerated bridge construction concrete columns with self-centering Fe-SMA bars subjected to near-fault ground motions

Experimental comparisons of repairable precast concrete shear walls with a monolithic cast-in-place wall

Repairability and Damage Assessment of Controlled Rocking Masonry Walls with Energy Dissipation Accessible in a Steel Base

Seismic response control of recentering steel frame with innovative SMA-high damping rubber dampers under sequential earthquakes

Experimental Study of Seismic Performance of an Innovative Low-Damage Self-Centering Composite Steel Plate Shear Wall

Seismic assessment of concrete buildings reinforced with shape memory alloy materials in different stories

Seismic Performance of a Novel Precast Beam-Column Joint Using Shape Memory Alloy Fibers-Reinforced Engineered Cementitious Composites

Seismic behaviour of self-centring hybrid steel frames equipped with SMA plates under mainshock–aftershock sequences

Seismic performance and analysis of resilient high-strength SRAC walls

Experimental study on the seismic performance of self-centering bridge piers incorporating ECC and superelastic SMA bars in the plastic hinge regions

Seismic performance of self-centering beam-column joints reinforced with superelastic shape memory alloy bars and engineering cementitious composites materials

Seismic demand assessment of self-centering steel plate shear walls

Seismic Response of Resilient Bridges with SMA-Based Rocking ECC-Reinforced Piers

Feasibility of using superelastic shape memory alloy in plastic hinge regions of steel bridge columns for seismic applications

Seismic assessment of RC structures having shape memory alloys rebar and strengthened using CFRP sheets in terms of fragility curves