Silk fibroin infilled 3D printed polymer-ceramic scaffold to enhance cell adhesion and cell viability

A. Logeshwaran,Chaitra Kabadi Srinivas,V. Venkatesh,Sunita Nayak
DOI: https://doi.org/10.1016/j.matlet.2023.134607
IF: 3
2023-05-30
Materials Letters
Abstract:3D printing technology has been a remarkably convincing strategy for fabricating scaffolds that can be used as a replacement for damaged tissue, which could help in regeneration and vascularization. In this study, polymer-ceramic composite 3D-printed scaffolds [Polycaprolactone(PCL), Hydroxyapatite(HAP) and Magnesium hydroxide(Mg(OH) 2 )] were fabricated, and infilled with silk fibroin(SF) to increase the cell adhesion in the scaffold. The cell adhesion was investigated by SEM analysis. It was observed that the presence of silk fibroin in the infilled region improves cell adhesion and cell viability; however, there was no significant difference in mechanical strength between SF-PCL Composite and PCL Composite, which were found to be 3.1 MPa and 2.92 MPa, respectively.
materials science, multidisciplinary,physics, applied
What problem does this paper attempt to address?