Abstract:Electromagnetic testing is the most widely used technique for the inspection of steel wire ropes. As one of the electromagnetic detecting approaches, the magnetic flux leakage (MFL) method has the best effect for the detection of broken wires. However, existing sensors based on MFL method still have some problems. (1) The size of the permanent magnet exciter is usually designed according to experience or rough calculation, and there is not enough depth analysis for its excitation performance; (2) Since the detectable angular range for a single Hall component is limited, Hall sensor arrays are often employed in the design of MFL sensors, which will increase the complexity of the subsequent signal processing due to the extensive use of Hall components; (3) Although the new magneto-resistance sensor has higher sensitivity, it is difficult to be applied in practice because of the requirement of the micron-level lift-off. To solve these problems, a sensor for the detection of broken wires of steel wire ropes based on the principle of magnetic concentration is developed. A circumferential multi-circuit permanent magnet exciter (CMPME) is employed to magnetize the wire rope to saturation. The traditional Hall sensor array is replaced by a magnetic concentrator to collect MFL. The structural parameters of the CMPME are optimized and the performance of the magnetic concentrator is analyzed by the finite element method. Finally, the effectiveness of the designed sensor is verified by wire breaking experiment. 1-5 external broken wires, handcrafted on the wire rope with a diameter of 24 mm, can be clearly identified, which shows great potential for the inspection of steel wire ropes.

Wire Rope Damage Detection Based on Magnetic Leakage and Visible Light

Nondestructive Detection of Wire Rope Damage Using Leakage Magnetic Technique based on Dual-Layer Sensors

Quantitative Nondestructive Testing of Broken Wires for Wire Rope Based on Multi-Image Fusion

Nondestructive Testing of Wire Ropes Based on Image Fusion of Leakage Flux and Visible Light

Wire Rope Defect Recognition Method Based on MFL Signal Analysis and 1D-CNNs

Ultrasonic Guided Wave Approach Incorporating SAFE for Detecting Wire Breakage in Bridge Cable

Quantitative Nondestructive Testing of Broken Wires for Wire Rope Based on Magnetic and Infrared Information

Quantitative Nondestructive Testing for Wire Rope Based on Multi-Source Information Fusion

Research on 3D MFL testing of wire rope based on empirical wavelet transform and SRCNN

Quantitative Nondestructive Testing of Wire Ropes Based on Features Fusion of Magnetic Image and Infrared Image

A Sensor for Broken Wire Detection of Steel Wire Ropes Based on the Magnetic Concentrating Principle

Research on Quantitative Detection of Wire Rope Damage Based on Weak Magnetic Excitation

Quantitative Identification of Internal and External Wire Rope Damage Based on VMD-AWT Noise Reduction and PSO-SVM

Study of Noise Reduction and Identification of Internal Damage Signals in Wire Ropes

A quantitative identification method based on CWT and CNN for external and inner broken wires of steel wire ropes

Improved Reconstruction of Magnetic Flux Leakage Signal From Wire Rope Damage Using Novel Smooth Function and Feature Peak Compensation

Quantitative detection of wire rope damage based on local structural characteristics

Damage Detection and Assessment of Broken Wires in Cables of a Bridge Based on Magnetic Flux Leakage

Accurate wire rope defect MFL detection using improved Hilbert transform and LSTM neural network

Enhancing Wire-Rope Damage Signals Based on a Radial Magnetic Concentrator Bridge Circuit

Multi-loop magnetisation method for detecting coal mine wire rope defects