Abstract:The thermodynamic, elastic, and electronic properties of D022-type Al3V and Al3Nb intermetallics were studied using the first-principle method. The results showed the pressure has profound effects on the structural, mechanical and electronic properties in both Al3V and Al3Nb. Thermodynamically, the formation enthalpies for Al3V and Al3Nb were derived, which agreed well with available experimental and theoretical values. Comparably, Al3Nb was a more stable phase with the more negative Hf than Al3V. Mechanically, the calculated elastic constants showed linearly increasing tendencies, and satisfied the Born's criteria from 0–20 GPa, indicating the mechanically stability of Al3V and Al3Nb under this pressure range. Further, the mechanical parameters (i.e., bulk modulus (B), shear modulus (G), and Young's modulus (E)) were derived using the Voigt-Reuss-Hill (VRH) method, and in good agreement with available experimental results at the ground state. All these parameters presented the linearly increasing dependences on the external pressure. The B/G ratios and Poisson's ratio indicated that the Al3V and Al3Nb crystals should exhibit brittle behavior at 0–20 GPa. Additionally, the bulk modulus can be obtained through fitting the Birch-Murnaghan equation (B0), computing by VRH method (BH), and deriving from the elastic theory (Brelax) in both intermetallics. The uniformity of these calculated bulk moduli in each compound exhibited the excellent reliability and self-consistency. In addition, Debye temperature was estimated from the average sound velocity. The Debye temperature showed an increasing dependence on the pressures. Finally, through density of states analysis, Al3V and Al3Nb were suggested to possess naturally metallic behavior. Under pressures, it was noted that the shapes of peaks and pseudogaps exhibited relative few changes, suggesting Al3V and Al3Nb has kept structurally stable up to 20 GPa. At zero pressure, Al3Nb was considered as a more structurally stable phase with the more number of bonding electrons per atom than Al3V. This conclusion was in consistent with the one drawn from the thermodynamic analysis.

Calculation of Mechanical Properties, Electronic Properties, and Thermodynamic Properties of AuAl Crystal: First‐Principles Calculation

Ab Initio Calculation of Structure and Thermodynamic Properties of Zintl Aluminide SrAl2

The first-principles calculations for the elastic properties of Zr2Al under compression

Study on Structures Stability, Mechanical Properties, and Electronic Properties of Alloy Ag–Au–Al: First‐Principles Calculations and Experiments

Physical properties and Debye temperature of Al7Cu2Fe alloy under various pressures analyzed by first-principles

Structural, Elastic, Anisotropic, Electronic, Thermal Properties and Tensile Strength of AlTM2Ti (TM = Ni, Fe, Cu, Co, Au) Studied by First-Principles Calculations

First-principles Study of Ni-Al Intermetallic Compounds under Various Temperature and Pressure

First-principles Calculations to Investigate Mechanical, Thermodynamic and Electronic Properties of Al2CuMg Intermetallic Compound under Pressure Effect

First-principles Study of the Structural and Elastic Properties of Cr2AlX (X=N, C) Compounds

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

The Structural, Elastic And Thermodynamic Properties Of Intermetallic Phases In Mg-Sn-Si-Ca(Sr) Alloys: A First-Principles Study

ELASTIC AND THERMODYNAMIC PROPERTIES OF NiAl AND Ni3Al FROM FIRST-PRINCIPLES CALCULATIONS

The Mechanical and Thermodynamic Properties of Heusler Compounds Ni2xal (X = Sc, Ti, V) under Pressure and Temperature: A First-Principles Study

First-principles explorations of mechanical, electronic and thermodynamic properties of (o, h)-AlCu3 compounds

First-Principles Investigation of Thermodynamic, Elastic and Electronic Properties of Al3v and Al3nb Intermetallics under Pressures

First-principles Investigation of the Elastic and Electronic Properties of the Binary Intermetallics in the Al–La Alloy System

A Density Functional Investigation of the Structural, Elastic and Thermodynamic Properties of the Au–Sn Intermetallics

First-Principles Study of the Structural, Mechanical, Electronic, and Thermodynamic Properties of AlCu2M (M = Ti, Cr, Zr, Sc, Hf, Mn, Pa, Lu, Pm) Ternary Intermetallic Compounds

First-principles calculation on the structural, elastic and thermodynamic properties of Ti-Al intermetallics

Computer Simulation: A Tool for Researching the Basic Physical Properties of NiAl and Ni<sub>3</sub>Al

Theoretical calculation of elastic properties and electronic structure of B2 iron aluminides and ternary iron—aluminum alloys