Abstract:Cellulose is mainly produced by plants, although many bacteria, especially those belonging to the genus <i>Gluconacetobacter</i>, produce a very peculiar form of cellulose with mechanical and structural properties that can be exploited in numerous applications. However, the production cost of bacterial cellulose (BC) is very high to the use of expensive culture media, poor yields, downstream processing, and operating costs. Thus, the purpose of this work was to evaluate the use of industrial residues as nutrients for the production of BC by <i>Gluconacetobacter hansenii</i> UCP1619. BC pellicles were synthesized using the Hestrin-Schramm (HS) medium and alternative media formulated with different carbon (sugarcane molasses and acetylated glucose) and nitrogen sources [yeast extract, peptone, and corn steep liquor (CSL)]. A jeans laundry was also tested. None of the tested sources (beside CSL) worked as carbon and nutrient substitute. The alternative medium formulated with 1.5% glucose and 2.5% CSL led to the highest yield in terms of dry and hydrated mass. The BC mass produced in the alternative culture medium corresponded to 73% of that achieved with the HS culture medium. The BC pellicles demonstrated a high concentration of microfibrils and nanofibrils forming a homogenous, compact, and three-dimensional structure. The biopolymer produced in the alternative medium had greater thermal stability, as degradation began at 240°C, while degradation of the biopolymer produced in the HS medium began at 195°C. Both biopolymers exhibited high crystallinity. The mechanical tensile test revealed the maximum breaking strength and the elongation of the break of hydrated and dry pellicles. The dry BC film supported up to 48 MPa of the breaking strength and exhibited greater than 96.98% stiffness in comparison with the hydrated film. The dry film supported up to 48 MPa of the breaking strength and exhibited greater than 96.98% stiffness in comparison with the hydrated film. The values obtained for the Young's modulus in the mechanical tests in the hydrated samples indicated low values for the variable rigidity. The presence of water in the interior and between the nanofibers of the hydrated BC only favored the results for the elasticity, which was 56.37% higher when compared to the dry biomaterial.

Swelling kinetics of cellulose / chondroitin sulfate membranes crosslinked with borax

Fabrication of Cellulose Nanofiltration Membranes by Reusing a Binary Solvent of EMIMAc Ionic Liquid and DMSO

Cellulose Modification by Recyclable Swelling Solvents

Low-cost bacterial cellulose production from agricultural waste for antibacterial applications

Obtaining polymeric composite membranes from lignocellulosic components of sugarcane bagasse for use in wastewater treatment

Use of Lignocellulosic Components of Sugarcane Bagasse to Obtaining Polymeric Composite Membranes

Effects of the coagulation bath on the properties of regenerated carboxymethylated cellulose films

Production of Bacterial Cellulose by Gluconacetobacter hansenii Using Corn Steep Liquor As Nutrient Sources

Simultaneous use of two-step fermentation and in-situ addition of chitosan oligosaccharide improving bacterial cellulose pellicle in the synthesis and various behaviors

Preparation of superabsorbent composite(s) based on dialdehyde cellulose extracted from banana fiber waste

Cellulose-based materials from orange bagasse employing environmentally friendly approaches

Chemical Modification of Cellulose Using a Green Route by Reactive Extrusion with Citric and Succinic Acids

Cellulose-xyloglucan composite film processing using ionic liquids as co-solvents

A Review of Cellulose and Cellulose Blends for Preparation of Bio-derived and Conventional Membranes, Nanostructured Thin Films, and Composites

Starch-based biocomposite membrane reinforced by orange bagasse cellulose nanofibers extracted from ionic liquid treatment

Bacterial cellulose production through the valorization of waste apple pulp and stale bread

Effect of Cellulose Nanocrystals from Different Lignocellulosic Residues to Chitosan/Glycerol Films

Effect of drying methods on the structure and properties of bacterial nanocellulose/MoS2 hybrid gel membranes and sphere-like particles for enhanced adsorption and photocatalytic applications

Green and Effective: Chitosan Blends with Fish Collagen and Aloe vera Exudate

Potential Application of Membrane Obtained from Sisal Bagasse in the Removal of Inhibitors from the Fermentation Process

Techno-economic Analysis and Life Cycle Assessment of Manufacturing a Cellulose Nanocrystal-Based Hybrid Membrane