Abstract:AIP Advances, Volume 12, Issue 6, June 2022. "Pits-and-grooves" patterns on the downstream accelerator grid surface had a severe effect on the thruster life; however, the sputtering patterns on the decelerator grid upstream surface were also observed after the thruster worked for over 3000 h. Reduction of the thruster diameter was adapted to prevent the erosion rate at the decelerator grid, but it decreased the thruster performance. Therefore, balancing the lifetime and performance was so critical for the optimization design of ion thruster. A three-dimension numerical model was established, and a Particle-In Cell-Monte-Carlo-Collision method was applied to investigating the hitting process and sputtering mechanism of a 30 cm ion thruster. Based on the experimental beam ion density profile in the plume, ion optics was divided into three regions, where the center region accounted for 73.3% of the effective extraction diameter of 30 cm. Beam ions in the center and the center-edge region were focused very well, and no ions striked directly on any grid surface, whereas ions at the edge were under-focused and had a cross-over interception. Decreasing the screen grid diameter from 13 to 12 could reduce the maximum erosion depth of the decelerator grid from 1.0 × 10−3 to 9.0 × 10−4, which only resulted in a 0.03% decrease of thruster performance. The maximum erosion depth of the accelerator grid caused by charge exchange xenon ion bombardment was 1.0 × 10−3 locating in the center region, which was twice that of 9.0 × 10−4. Improving the flatness was the way to extend the thruster lifetime. The maximum error of simulation was about 4.38%. The simulation results can provide technical reference for the optimization design of the ion thruster.

Spatial Distribution of the Sputtering Material of Discharge-Chamber Walls Emitted from a Stationary Plasma Thruster

Ion behavior in low-power magnetically shielded and unshielded Hall thrusters

Volumetric Erosion Rate Reduction of Hall Thruster Channel Wall During Ion Sputtering Process

Research on the life-limiting sputtering mechanism of 30 cm ion thruster

Numerical Study of Azimuthal Sheath Structure and Asymmetric Anomalous Erosion in a Stationary Plasma Thruster

Kinetic effects in a Hall thruster discharge

Numerical Study of Hall Thruster Plume and Sputtering Erosion

Study on Sputtering Yield of Hall Thruster Discharge Chamber Wall

Effects of Erosion Surface on Near Wall Conductivity (NWC) in the Hall-type Stationary Plasma Thrusters

Pulsed plasma thruster exhaust reconstruction.

Review of Plasma-Induced Hall Thruster Erosion

Hybrid–PIC Simulation of Sputtering Product Distribution in a Hall Thruster

Effects of initial ion velocity, magnetic field and plasma density profiles in simulating the plasma plume in a Hall thruster

Time-evolution of the ion velocity distribution function in the discharge of a Hall effect thruster

Sputtering of Mo and Ag with xenon ions from a radio-frequency ion thruster

Particle‐in‐cell Simulation of the Effect of Curved Magnetic Field on Wall Bombardment and Erosion in a Hall Thruster

The Effect of Electron Distribution Function Anisotropy on Space Charge Saturated Sheath Critical Parameters in Hall Thrusters

Magnetic shielding of a laboratory Hall thruster. I. Theory and validation

Smoothing of Discharge Inhomogeneities at High Currents in Gasless High Power Impulse Magnetron Sputtering

Three-Dimensional Kinetic Simulation of an Ion Thruster Plume with Carbon Backsputtering in a Vacuum Chamber