Abstract:The design optimization of a direct-drive permanent magnet synchronous generator (DDPMSG) is of great significance for wind turbines because of its unique advantages. This paper proposes a two-stage model to realize multi-objective design optimization for a 6 MW DDPMSG. In the first stage, a surrogate optimized response surface model based on an improved sparrow search algorithm (ISSA) was established for modeling the cogging torque and generator efficiency. In the second-stage model, a multi-objective optimization model is proposed to optimize the cogging torque and generator efficiency of the DDPMSG. Finally, the proposed two-stage model was used for a 6 MW DDPMSG design optimization, and the simulation results demonstrated the superiority and rationality of the proposed model. In the first-stage model, the proposed surrogate model based on the ISSA had a better modeling accuracy and lower errors. Compared with traditional response surface models and correlation analysis models, the proposed optimized surrogate model reduced errors in the cogging torque by 34.63% and 42.97%, respectively, while the errors in the efficiency models were reduced by 12.92% and 60.78%, respectively, which indicates the superiority of the first-stage model. In the second stage, compared with the single-objective optimization model, the multi-objective optimization model achieved a trade-off optimization between the cogging torque and the efficiency. Compared with the cogging torque optimization model, the proposed model optimized the efficiency by 101.41%. Compared with the efficiency optimization model, the proposed model reduced the cogging torque by 16.67%. These results verified the superiority and rationality of the second-stage model.

Design and Optimization of a New Half Direct-Driven MW-Scale Axial Flux Permanent Magnet Generator for Wind Turbine

Enhanced Ventilation and Thermal Performance by Skewed Through Holes on Rotor Yoke in Forced Air-Cooled Permanent Magnet Wind Generators

Optimization Design of a Permanent Magnet Synchronous Generator for a Potential Energy Recovery System

Design of A 10 Mw Dual-Stator Superconducting Permanent Magnet Wind Power Generator

Design Aspects for Permanent Magnet Superconducting Wind Power Generators

Electromagnetic Design And Optimization Of Dual-Stator Brushless Doubly-Fed Wind Power Generator With Cage-Barrier Rotor

Design Of A Dual-Stator Superconducting Permanent Magnet Wind Power Generator With Different Rotor Configuration

Influence of Design Parameters on Output Torque of Novel Doubly-Fed Flux-Switching Permanent Magnet Machines

Optimized Design of High Torque Density Permanent Magnet Synchronous Motor with Halbach Magnet

Voltage regulation Rate and THD optimization analysis of coreless axial flux PM synchronous generator for wind power generation

Design of 20 MW direct‐drive permanent magnet synchronous generators for wind turbines based on constrained many‐objective optimization

A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator

Multiobjective Design Optimization of a Double-Sided Flux Switching Permanent Magnet Generator for Counter-Rotating Wind Turbine Applications

Unit Power Factor Control of Direct-Drive Permanent Magnet Wind Generator

Design And Optimization Of 8mw Directly Driven Surface Mounted Permanent Magnet Wind Generators

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Multi-Objective Optimal Design of High-Speed Surface-Mounted Permanent Magnet Synchronous Motor for Magnetically Levitated Flywheel Energy Storage System

Design and Analysis of Axial Flux Permanent Magnet Generator for Direct-Driven Wind Turbines

Design and Performance Analysis of Dual-Stator Brushless Doubly-Fed Machine with Cage-Barrier Rotor

A Counter-Rotating Double-Rotor Axial Flux Permanent Magnet Generator for Wind Turbine Applications: Design, Simulation, and Prototyping