Abstract:Cam-lobe radial-piston hydraulic motors are widely used in large heavy-duty machinery as direct-drive components of hydraulic systems. Due to their extremely high output torque and power density, the wet brake equipped with the hydraulic motors are necessary to achieve ultra-high braking torque in a compact space. However, due to a large number of internal friction pairs and small fit clearance between multiple friction pairs in wet brake, the rotation of the friction pairs in non-braking state will cause large friction torque loss and obvious temperature rise, thereby leading to the thermal failure of wet brake. How to optimize the structure of friction pairs to reduce the temperature rise of wet brake in non-braking state is a persistent challenge. Existing structure optimization design approaches of friction pairs in brakes mainly focus on the structure of each friction pair, which ignore the effect of fit clearance between the friction pairs on the temperature rise of brakes. Nevertheless, the fit clearance between friction pairs is an important factor that affect the temperature rise. For that, this study proposes a two-step structure optimization design approach of friction pairs for low-temperature rise wet brake in hydraculic motor, which simultaneously considers the fit clearance between the friction pairs and the structure of each friction pair. In this approach, the design process could be divided into two steps: firstly, the influence of fit clearance between multiple friction pairs on the temperature rise of wet brake in non-braking state is analyzed and optimized by the temperature rise theoretical model; secondly, in order to further reduce the temperature rise of wet brake, the oil groove structure of each friction plate are introduced and optimized by fluid-solid-thermal coupling simulation method. By this approach, the low-temperature rise structure of friction pairs with the optimized fit clearance between multiple friction pairs and oil grooves of each friction plate. Finally, a series of experiments are conducted to verify the effectiveness of the design approach. The result show that the temperature rise of wet brake could be effectively reduced 12% by optimizing the structure of wet brake, demonstrating that the structure optimization design approach could provide a theoretical guidance to design low-temperature rise wet brake for large torque hydraulic motors.

Intelligent Cooling Devices for Truck’s Brake System

Analyzing Performance of Automobile Brake Drum in 3D Thermo-elastic Coupling Field

The Design of the Automobile Brake Cooling System

Experimental Study on Air-Hydraulic Brake System

Structure Optimization Design Approach of Friction Pairs for Low-Temperature Rise Wet Brake in Hydraulic Motor

Design of Brake Disc Automatic Detection System Based on PC

System of monitoring and early warning for temperature of truck Brake shoe

Research progress of temperature field calculation of disc brake braking interface based on numerical analysis

The Research and Development of Motor Cooling Control System Based on Electronic Parking Brake Test Bench

Modeling and Adaptive Control of the Electro-Hydraulic Braking System of Low-Floor Vehicle

Study on Diesel Engine Coolant Temperature Control Strategy with Feedforward

Braking temperature investigation on oil tank truck for anticipation of brake failure

Brake Drum Temperature Rise and Its Influence on Truck Driving Safety in Tunnel Groups Section

Research on thermal-solid coupling behavior of drum brake under emergency braking on slopes

Hydraulic Pressure Control And Parameter Optimization Of Brake-By-Wire System Based On Driver-Automation Cooperative Driving

Vehicle Braking Force Distribution with Electronic Pneumatic Braking and Hierarchical Structure for Commercial Vehicle

Technology Development Analysis on Low Carbon for Power of Heavy-Duty Commercial Vehicle

Study on the influence of running parameters on the temperature field of disc brake on long downhill road

Research on Measurement Principle and Key Measuring Devices of Pressure Change Rate for Electronically Controlled Pneumatic Brake of Commercial Vehicle Based on Poiseuille’s Law

Research on the automotive braking performance

The Integrated Control of Regenerative Braking System and Air Braking ABS on Electric Wheel Drive Urban Bus