Abstract:This study set out to examine the unconventional use of raw oil shale (OS) as fine aggregate in concrete instead of its traditional utilisation as a pollutant energy source aiming to hinder the depletion of natural resources. Oil shale particles have been used to replace sand in concrete with 30 wt.-% and 50 wt.-% ratios. Part of the used OS particles was treated with silane prior to their addition in concrete. The fresh, mechanical, and durability properties, along with the micro-properties and surface chemistry of mixtures, were analysed by running the slump, compressive strength, permeability, scanning electron microscopy (SEM) and fourier transform infrared spectroscopy (FTIR) tests, respectively. Five concrete mixtures consisting of 30 samples with the size of 150 mm x 150 mm x 150 mm were prepared to serve the testing programme of the study. The results revealed the formation of a well-bonded interfacial transition zone between untreated OS particles and the cementitious matrix due to the presence of pozzolanic materials in OS. However, micro cracks and enlarged capillary pores were witnessed in treated OS mixtures along with a weak interfacial transition zone between the treated OS and the cementitious matrix. Moreover, the use of 30 wt.-% untreated OS reduced the water absorption of concrete by 9% (absorption rate of 9.5%), while other mixtures experienced an increase in their water absorption with a maximum increase of 42% when using 50 wt.-% treated OS (absorption rate of 10.7%). All mixtures attained a reduction in their compressive strength compared to control sample when employing treated and untreated OS in concrete, with a minimum reduction of 13% when using 30 wt.-% untreated OS (compressive strength of 26 MPa). The strength reduction in untreated OS mixtures is due to the formation of free CaO and free SiO2, which promote concrete expansion. The interference between silane and kerogen in OS was the main reason behind the strength reduction in treated OS mixtures. However, this reduction in mixtures’ strength is considered minimal, allowing for their potential use in different construction applications like rigid pavement.

Mechanical properties of heat damaged oil shale ash concrete

Effect of grinded oil shale inclusion on some properties of concrete mixtures

Investigation on the Properties of Concrete Containing Oil Shale Waste Ash as a Substitute for Cement

Utilizing of oil shale ash as a construction material: A systematic review

Potential uses of Jordanian spent oil shale ash as a cementive material

Utilisation of raw oil shale as fine aggregate to replace natural sand in concrete: Microstructure, surface chemistry and macro properties

Evolution of Durability and Mechanical Behaviour of Mud Mortar Stabilized with Oil Shale Ash, Lime, and Cement

Mechanical Properties of Lightweight Aggregate Concrete Containing Unground Palm Oil Fuel Ash as Partial Sand Replaceme

Effect of Waste Oil Shale Ash on Properties of Asphalt Cement and Asphalt Concrete Mixtures: State of the Art

Treated Oil Shale Ashes as Cement and Fine Aggregates Substitutes for the Concrete Industry

Study on the Durability of High-Content Oil Shale Concrete

Effect of olive waste ash on the properties of high‐strength geopolymer concrete

Investigating the Influence of Oil Shale Ash and Basalt Composite Fibres on the Interfacial Transition Zone in Concrete

A Review on The Compressive Strength and Workability of Concrete with Agricultural Waste Ash as Cement Replacement Material

Effect of partial replacement of cement with rice husk ash on concrete properties

Use of Oil Palm Shell As an Aggregate in Cement Concrete: A Review

Dynamic properties of mortar with oyster shell sand replacement

Preparation of High Strength and Lightweight Wall Materials Using Oil Shale Ash As Raw Materials

Effectiveness of Ternary Blend Incorporating Rice Husk Ash, Silica Fume, and Cement in Preparing ASR Resilient Concrete

Effects of waste oyster shell replacing fine aggregate on the dynamic mechanical characteristics of concrete