Abstract:Many nations have committed to becoming carbon neutral by 2050 as a means of addressing the global warming challenge. To achieve carbon neutrality, transportation is one of the most essential and important tasks. Energy‐efficient pure electric vehicles (EVs) and hybrid electric vehicles (HEVs) with green energy power are being developed in response to the worldwide energy and environmental crises, as the potential replacements for the current generation of combustion‐engine automobiles. EVs require batteries more than ever before. In this perspective, lithium‐ion batteries (LIBs) stand out as remarkable energy storage technologies and have been widely used due to their numerous impressive benefits. Owing to LIBs sensitivity to temperature, EVs typically use the battery thermal management system (BTMS). The working temperature span of a lithium‐ion battery in an electric car is 15°C–35°C, which is achieved by the use of a BTMS. The production of internal heat during charging and discharging also affects how well lithium‐ion batteries work. A battery heat control system is therefore required. The temperature of the LIB pack might be efficiently controlled by liquid‐cooled systems in discharge and charge scenarios. Based on Al2O3 nanofluid (NF), the current experimental study suggests a novel active cooling technology for regulating the heat produced by the 18650‐format lithium‐ion batteries. A thorough analysis is conducted on the impact of charge/discharge C‐rates, Al2O3 nanoparticle (NP) volume fractions, inflow coolant velocity, and intake liquid temperature on the thermal efficiency of the LIB pack. By incorporating aluminum oxide NPs into the water at varying volume fractions of 0.3%, 0.5%, and 1%, the LIB pack's maximum temperature was significantly reduced by 7.9%, 18.09%, and 19.56%, respectively. With increase in mass flow rate of coolant from 0.0290 to 0.5810 kg/s, the maximum temperature has been substantially reduced by 3.7%–8.6%. Results show that using higher fluid inflow temperature significantly increased both the highest experienced temperature and temperature diversity throughout the discharge operation by about, 6°C and 5°C, respectively. The outcomes of the study indicate that NFs exhibit superior cooling performance compared to conventional coolants such as water and ethylene glycol.

A novel battery cooling system using nanofluids on MATLAB Simulink

Performance investigation of electric vehicle battery thermal management system using nano fluids as coolants on ANSYS CFX software

Experimental investigation of change in performance parameters on cooling of lithium‐ion battery pack using nanofluids

Battery Thermal Management System Design: Role of Influence of Nanofluids, Flow Directions, and Channels

Enhancement of an Air-Cooled Battery Thermal Management System Using Liquid Cooling with CuO and Al2O3 Nanofluids under Steady-State and Transient Conditions

Optimization of simultaneous utilization of air and water flow in a hybrid cooling system for thermal management of a lithium-ion battery pack

Numerical Investigation of Nanofluid as a Coolant in a Prismatic Battery for Thermal Management Systems

Novel hybrid thermal management system for preventing Li-ion battery thermal runaway using nanofluids cooling

Numerical analysis and machine learning for battery thermal performance cooled with different fluids

Thermoeconomic Analysis of a Compact Active Coolant System for Lithium-Ion Battery Pack

Numerical Simulation of Immersed Liquid Cooling System for Lithium-Ion Battery Thermal Management System of New Energy Vehicles

Numerical Simulation on Heat Transfer Performance of a Liquid Cold Plate for Cooling of the Electric Vehicle Battery

Simulation of nanofluid-cooled lithium-ion battery during charging: A battery connected to a solar cell

Experimental investigation on an innovative serpentine channel‐based nanofluid cooling technology for modular lithium‐ion battery thermal management

Thermal management improvement for a pack of cylindrical batteries using nanofluids and topological modifications

Numerical investigation and optimization of liquid battery thermal management system considering nanofluids, structural, and flow modifications under high discharge cycles

Thermal performance assessment for an array of cylindrical Lithium-Ion battery cells using an Air-Cooling system

Thermohydraulic performance of ammonia, isopropanol, water and nanofluids as cooling fluid for lithium-ion 1C and 3C rating batteries

Experimental studies on micro-channel heat sink with different heat transfer fluid

Thermal Performance Analysis of Liquid Cooling System in Lithium-ion Battery

Improving lithium battery cooling: analyzing the impact of air flow, nanofluid flow, and phase change materials