Abstract:Numerous adsorbents have been applied for Heavy Metals (HMs) removal from contaminated water. The aim of this review was to critically analyze the status of research in HMs detection and adsorption, focusing on the adsorption approaches for better defining the corresponding future challenges and their potential solutions. Present research demonstrates the promising outlook for using remote sensing technology in the preliminary selection of contaminated areas before final HMs detection using spectrometry, microwave or electrochemical sensors. Adsorption can then be applied in treating HMs contaminated water due to its high effectiveness and low-cost. Natural zeolites showed 90 %-100 % Pb2+, 2 + , 95 % Cd2+ 2 + and 100 % Cu2+ 2 + removal from water, their effectiveness is affected by initial pH, and adsorbent dosage and size. As synthesized zeolites, zeolitized pumice waste showed 100-500 mg/g of HMs adsorption at pH 4.0-5.0, 57 mg/g Zn2+ 2 + by oxalate-loaded zeolites and 682 mg/g Pb2+ 2 + and 122 mg/g Ni2+ 2 + by zeolite nanoparticle impregnated polysulfone membrane from wastewater. Activated carbon exhibited 99 %-100 % Hg2+, 2 + , 93 % Cu2+ 2 + and 99 % Co2+ 2 + removal from water under acidic environment. Biochar is more ecofriendly and demonstrated its effectiveness in removing up to 98 % Cd2+, 2 + , 97 % Cu2+, 2 + , 99 % Pb and 94 % Zn2+ 2 + from water. Chitosan showed 755 mg/g Pb2+, 2 + , 979 mg/g Cd2+ 2 + and 877 mg/g Cu2+ 2 + removal at pH 2.0-6.0 from wastewater. Peat moss exhibited 96 % Cu2+ 2 + and 50 % Cr6+ 6 + removal from wastewater at lower pH. Similarly, bioremoval showed 143 mg/g Zn2+ 2 + (algae) adsorption at pH 6.0 in, and 90 % Cr6+ 6 + and 98 % Cu2+ 2 + removal by biomass ash. Recently, carbon, magnetic and titanium nanotubes/composites have shown high efficiency and selectivity in HMs removal, but their preparation is often more expensive than their counterparts. In addition, adding enhancement solutions promoted HMs adsorption and reduced treatment time. Chemical precipitation demonstrated feasibility to recycle and recover extracted HMs and spent adsorbent. This review demonstrates the need for highly selective and efficient adsorbent, and guides the future researchers to make funtionalized and organic-inorganic composite HMs adsorbents.

Removal of Cd2+, Pb2+ and Ni2+ from water by adsorption onto magnetic composites prepared using humic acid from waste biomass

Adsorption of MB and Pb(II) before and after magnetic modification: Performance and mechanism

Mussel-inspired Magnetic Adsorbent MnO2/PDA@Fe3O4 for Removing Heavy Metal Ions Contaminants in Single and Mixed Systems

Adsorption of heavy metals in water by modifying Fe3O4 nanoparticles with oxidized humic acid

Synthesis of Magnetic Rectorite/humic Acid/chitosan Composite for Removal of Heavy Metal Ions from Water

Enhanced adsorption and co-adsorption of heavy metals using highly hydrophilicity amine-functionalized magnetic hydrochar supported MIL-53(Fe)-NH2: performance, kinetics, and mechanism studies

In situ polymerization of magnetic graphene oxide-diaminopyridine composite for the effective adsorption of Pb(II) and application in battery industry wastewater treatment

Adsorption Studies of Pb(II) and Cd(II) Heavy Metal Ions from Aqueous Solutions Using a Magnetic Biochar Composite Material

A multifunctional adsorbent based on 2,3-dimercaptosuccinic acid/dopamine-modified magnetic iron oxide nanoparticles for the removal of heavy-metal ions

Utilization of peanut hull hydrochar /beta cyclodextrin/Fe3O4 magnetic composite for lead ion removal from water solution

Encapsulated Green Magnetic Nanoparticles for the Removal of Toxic Pb2+ and Cd2+ from Water: Development, Characterization and Application.

Preparation of Humic Acid-Bentonite-Polymer Composite and Investigation of Its Efficiency for the Removal of Nickel, Cadmium and Lead Ions from Wastewater

Simple hydrothermal synthesis of magnetic MnFe2O4-sludge biochar composites for removal of aqueous Pb2+

Highly efficient removal of bivalent heavy metals from aqueous systems by magnetic porous Fe3O4-MnO2: Adsorption behavior and process study

Selective adsorption of heavy metals from water by a hyper-branched magnetic composite material: Characterization, performance, and mechanism

Judicious fabrication of bifunctionalized graphene oxide/MnFe2O4 magnetic nanohybrids for enhanced removal of Pb(II) from water

Simultaneous scavenging of Cd(II) and Pb(II) from water by sulfide-modified magnetic pinecone-derived hydrochar

Synthesis of biochar-iron oxide magnetic nanocomposite for efficient and rapid removal of Pb(II) heavy metal from water

A Novel Quickly Preparation Hmbc (Mnox-Obc) for High Adsorption Performance of Pb(Ii) and Cd(Ii): Behavior and Mechanism

Synergistic removal of Pb(II), Cd(II) and humic acid by Fe3O4@mesoporous silica-graphene oxide composites

Heavy Metals Detection and Removal from Contaminated Water: A Critical Review of Adsorption Methods