Abstract:The fluxes of sensible heat (H) and latent heat (LE), which are generally the important parts of the energy and mass balances over glacier surfaces, are widely quantified by the bulk method. However, due to the difficulty of determining the aerodynamic roughness length z(0m) in this method, H and LE values may still have large uncertainties with significant inaccuracy. To acquire reliable varying and intrinsic z(0m) values, new simpler parameterizations for z(0m) values at different ranges of the friction velocity u(*b) were fitted in this study. The method was implemented using the related meteorological data and glacial sublimation/condensation measured at the top of the August-one glacier (4817 m asl) in the Qilian Mountains from 1 July 2016 to 15 August 2017. The parameterization shows that z(0m) increased sharply when u(*b) exceeded 0.43 m/s (the approximate threshold value) and that the effect of snowdrift was slight for the hourly z(0m) values in the range 0.15 <= u(*b) <= 0.43 m/s, which could thus be used to calculate the daily z(0m). During the wet period (1 July to 24 September 2016 and 5 May to 15 August 2017), the turbulent fluxes calculated by the bulk method showed that net radiation R-net was the primary source of surface energy (60.7 w/m(2)), whereas during the dry period (25 September 2016 to 4 May 2017), the main heat sink was the positive H (28.5 w/m(2)) rather than the negative R-net (-10.0 w/m(2)). Plain Language Summary The profile method and the bulk method have been applied to quantify turbulent fluxes and sublimation/condensation, and the bulk method is more widely used because it is insensitive to observation errors. However, determination of the aerodynamic roughness lengths in the bulk method remains a large challenge. So we tried to acquire reliable varying and intrinsic roughness length for momentum through its parametric analysis. The related meteorological data and glacial sublimation/condensation were measured over a mountain glacier. Hourly roughness lengths in the transitional range affected slightly by snowdrift were found with the approximate threshold value. The comparison provided here verifies that these values are reliable, although this method is relatively rough. The z(0m) parameterization can be regarded as an important basis of turbulent heat flux research. Therefore, in addition to z(0m) parameterization, it can also be very meaningful to further discuss the temporal variation of meteorology and turbulent heat fluxes. Further research is needed and very important to improve our understanding of energy and mass exchange between the glacier surface and atmosphere, especially in arid and semiarid regions.

The impacts of roughness length on the simulation of land-atmosphere water and heat exchanges over the Yarlung Zangbo Grand canyon region

An Evaluation of the Mellor-Yamada-Janjić Formulation Parameters for the QNSE Scheme in the WRF Model over the Lower Yangtze River Valley

Spatializing the roughness length of heterogeneous urban surfaces to improve the WRF simulation-Part 2: Impacts on the thermodynamic environment

Impacts of Urbanization and its Parameters on Thermal and Dynamic Fields in Hangzhou: A Sensitivity Study Using the Wrf-Urban Model

Simulation Performance of Temperature and Precipitation in the Yangtze River by Different Cumulus and Land Surface Schemes in RegCM4

Simple Parameterization of Aerodynamic Roughness Lengths and the Turbulent Heat Fluxes at the Top of Midlatitude August‐One Glacier, Qilian Mountains, China

Improving the Noah Land Surface Model in Arid Regions with an Appropriate Parameterization of the Thermal Roughness Length

Modification Tests for the Coefficient of Turbulent Mixing Length Scale in QNSE Scheme in the WRF Model

Effects of Land Surface Schemes on WRF-Simulated Geopotential Heights over China in Summer 2003*

Impacts of Urbanization and Its Parameters on Thermal and Dynamic Fields in Hangzhou: A Sensitivity Study Using the Weather Research and Forecasting Urban Model

Comparison of Soil Water and Heat Transfer Modeling over the Tibetan Plateau Using Two Community Land Surface Model (CLM) Versions

Satellite-Based Estimation of Roughness Length over Vegetated Surfaces and Its Utilization in WRF Simulations

Sensitivity experiments of RegCM4 using different cumulus and land surface schemes over the upper reaches of the Yangtze river

Elucidating Dominant Factors Affecting Land Surface Hydrological Simulations of the Community Land Model over China

Performances of CoLM and NCAR_CLM3.0 in Simulating Land-Atmosphere Interactions over Typical Forest Ecosystems in China Part I. Preliminary Analysis of the Simulations Based on Different Models

Integrating optimized cumulus and TOFD schemes for heavy precipitation forecasting in the Yarlung Tsangbo Grand Canyon

Convection-permitting Modeling over the Tibetan Plateau Improves the Simulation of Meiyu Rainfall During the 2011 Yangtze Plain Flood

Evaluating and improving simulations of diurnal variation in land surface temperature with the Community Land Model for the Tibetan Plateau

Surface Roughness Length Dynamic over Several Different Surfaces and Its Effects on Modeling Fluxes

Estimates of the Land Surface Hydrology from the Community Land Model Version 5 (CLM5) with Three Meteorological Forcing Datasets over China

Climate Impacts of Parameterizing Subgrid Variation and Partitioning of Land Surface Heat Fluxes to the Atmosphere with the NCAR CESM1.2