Abstract:Photocatalytic degradation can be increased by improving photo-generated electrons and broadening the region of light absorption through conductive polymers. In that view, we have synthesized Polyaniline (PANI) with CdS, CdS-ZnS, and CdS-TiO2 nanocomposites using the chemical precipitation method, characterized and verified for the photo-degradation of Acid blue-29 dye. This paper provides a methodical conception about in what way conductive polymers "PANI" enhances the performance rate of composite photocatalysts (CdS, CdS-ZnS and CdS-TiO2). The nanocomposites charge transfer, molar ratio, surface morphology, particle size, diffraction pattern, thermal stability, optical and recombination of photo-generated charge carrier properties were determined. The production of nanocomposites and their efficient photocatalytic capabilities were observed. The mechanism of photocatalysis involved with PC, CZP and CTP nanocomposites are well presented by suitable diagrams representing the exchange of electrons and protons among themselves with supported equations. We discovered that increasing the number of nanocomposites in the membranes boosted both photocatalytic activity and degradation rate. CdS-Zinc-PANI (CZP) and CdS-TiO2-PANI(CTP) nanocomposites show entrapment at the surface defects of Zinc and TiO2 nanoparticles due to the demolition of unfavorable electron kinetics, and by reducing the charge recombination, greater photocatalytic activity than CdS-PANI (CP) with the same nanoparticle loading was achieved. With repeated use, the photocatalysts' efficiency dropped very little, hinting that they may be used to remove organic pollutants from water. The photocatalytic activity of CZP and CTP photocatalytic membranes was greater when compared to CdS-PANI, which may be due to the good compatibility between CdS and Zinc and TiO2, as well efficient charge carrier separation. PANI can also increase the split-up of photo-excited charge carriers and extend the absorption zone when combined with these nanoparticles. As a result, the development of outrageous performance photocatalysts and their potential uses in ecological purification and solar power conversion has been facilitated. The novelty of this article is to present the degradation of AB-29 Dye using nanocomposites with polymers and study the enhanced degradation rate. Few studies have been carried out on polymer nanocomposites and their application in the degradation of AB-29 dyes and remediation of water purposes. Nanoparticle CdS is a very effective photocatalyst, commonly used for water purification along with nanoparticle ZnS and TiO2; but cadmium ion-leaching makes it ineffective for practical and commercial use. In the present work, we have reduced the leaching of hazardous cadmium ions by trapping them in a polyaniline matrix, hence making it suitable for commercial use. We have embedded ZnS and TiO2 along with CdS in a polyaniline matrix and compared their photocatalytic activity, stability, and reusability, proving our nano-composites suitable for commercial purposes with enhanced activities and stabilities, which is a novelty. All synthesized nanocomposites are active within the near-ultraviolet to deep infrared (i.e., 340-850 nm). This gives us full efficiency of the photocatalysts in the sunlight and further proves the commercial utility of our nanocomposites.

Enhanced sunlight-absorption of Fe2O3 covered by PANI for the photodegradation of organic pollutants and antimicrobial inactivation

Conjugated Conducting Polymers PANI Decorated Bi12O17Cl2 Photocatalyst with Extended Light Response Range and Enhanced Photoactivity

Electrochemically-deposited PANI on iron mesh-based metal-organic framework with enhanced visible-light response towards elimination of thiamphenicol and E. coli

Enhanced Photoreduction Degradation of Polybromodiphenyl Ethers with Fe3O4-g-C3N4 under Visible Light Irradiation.

MoS 2 /polyaniline (PANI)/polyacrylonitrile (PAN)@BiFeO 3 bilayer hollow nanofiber membrane: photocatalytic filtration and piezoelectric effect enhancing degradation and disinfection

Facile synthesis of silver chloride-polyaniline nanocomposites and its photocatalytic activity for the degradation of methylene blue

Investigation of structural, optical, and magnetic properties of NiFe2O4 for efficient photocatalytic degradation of organic pollutants through photo fenton reactions

Highly efficient tin oxide and polyaniline-tin-oxide nanostructured materials for photocatalytic degradation of organic dyes

Superior photocatalytic and electrochemical activity of novel WS2/PANI nanocomposite for the degradation and detection of pollutants: Antibiotic, heavy metal ions, and dyes

Antimicrobial photocatalytic PANI based-composites for biomedical applications

Hierarchical PANI/ZnO nanocomposite: synthesis and synergistic effect of shape-selective ZnO nanoflowers and polyaniline sensitization for efficient photocatalytic dye degradation and photoelectrochemical water splitting

Photocatalytic Degradation of Methylene Blue Dye using PANI‐CuFe2O4 Nano Composite

Enhanced photocatalytic performance of polyaniline nanoparticles for efficient dye degradation under simulated sunlight

Synthesis of Polyaniline Supported CdS/CdS-ZnS/CdS-TiO2 Nanocomposite for Efficient Photocatalytic Applications

Photocatalytic performance of PANI modified TiO2: Degradation of refractory organic matter

Photocatalytic degradation of antibiotics by N-doped carbon nanoflakes-nickel ferrite composite derived from algal biomass

Polyaniline modified MIL-100(Fe) for enhanced photocatalytic Cr(VI) reduction and tetracycline degradation under white light

Inorganic–organic nanohybrid of MoS2-PANI for advanced photocatalytic application

Synthesis of ferrihydrite/polyaniline composite using waste Fe(III)/EPS-cultures with polyaniline and its application for tetracycline photo-Fenton degradation

Synergistic Effect of PANI and NiFe2O4 for Photocatalytic Hydrogen Evolution under Visible Light

Sunlight responsive Fe 3 O 4 embedded GO sponge wrapped by PANI for photocatalytic abatement of rhodamine B dye