Infrared Spectra and Hydrogen-Bond Configurations of Water Molecules at the Interface of Water-Insoluble Polymers under Humidified Conditions

Yuka Ikemoto,Yoshihisa Harada,Masaru Tanaka,Shin-nosuke Nishimura,Daiki Murakami,Naoya Kurahashi,Taro Moriwaki,Kosuke Yamazoe,Hitoshi Washizu,Yoshiki Ishii,Hajime Torii
DOI: https://doi.org/10.1021/acs.jpcb.2c01702
IF: 3.466
2022-05-31
The Journal of Physical Chemistry B
Abstract:Elucidating the state of interfacial water, especially the hydrogen-bond configurations, is considered to be key for a better understanding of the functions of polymers that are exhibited in the presence of water. Here, an analysis in this direction is conducted for two water-insoluble biocompatible polymers, poly(2-methoxyethyl acrylate) and cyclic(poly(2-methoxyethyl acrylate)), and a non-biocompatible polymer, poly(<i>n</i>-butyl acrylate), by measuring their IR spectra under humidified conditions and by carrying out theoretical calculations on model complex systems. It is found that the OH stretching bands of water are decomposed into four components, and while the higher-frequency components (with peaks at ∼3610 and ∼3540 cm<sup>-1</sup>) behave in parallel with the C═O and C-O-C stretching and CH deformation bands of the polymers, the lower-frequency components (with peaks at ∼3430 and ∼3260 cm<sup>-1</sup>) become pronounced to a greater extent with increasing humidity. From the theoretical calculations, it is shown that the OH stretching frequency that is distributed from ∼3650 to ∼3200 cm<sup>-1</sup> is correlated to the hydrogen-bond configurations and is mainly controlled by the electric field that is sensed by the vibrating H atom. By combining these observed and calculated results, the configurations of water at the interface of the polymers are discussed.
chemistry, physical
What problem does this paper attempt to address?